Use and Care Manual

40 - English
OPERATION
Fig. 68
PROGRAMMING THE OUTDOOR KEYPAD
See Figure 68 - 69.
Install outdoor keypad and battery as described earlier
in the Installation section.
Open the garage door.
Open the cover on the outdoor keypad. Enter the default
security code —1234—and press ENTER.
If the code was entered successfully, the keypad will beep
indicating that it is ready for you to enter a new security
code.
Enter your desired security code and press ENTER. The
code must be 4 digits and must be entered within 30
seconds.
If the code was entered successfully, the keypad will beep
indicating that it is ready for you to confirm the new code.
Enter the new security code and press ENTER.
Press and hold the SET button on the garage door
opener’s console until the LED lights flash three times.
Enter your security code into the keypad and press
PROGRAM. If entered correctly, the LED lights on the
garage door opener will flash three times to confirm that
the keypad and opener are synced.
After the keypad has been synced, enter your security
code and press ENTER to open and close the garage
door.
PROGRAMMING THE REMOTE CONTROLS
See Figure 69 - 70.
Press and hold the SET button on the garage door
opener’s console until the LED lights flash three times.
Press and hold either button on the remote control for
three seconds to sync the button the garage door opener.
The LED lights on the garage door opener will flash three
times to confirm that the button and the opener are
synced.
NOTE: The second button can be synced to another
garage door opener.
Repeat this process to sync the other remote.
After the remote controls have been synced, press the
left or right button on either remote control to open and
close the garage door.
Store the remotes on your car’s visor using the visor clip.
“1234”
Program
Button
Enter
Button
Set
Program
Console
Door
Remote
Control
Buttons
Fig. 69
Fig. 70