Use and Care Manual
41 - English
MAINTENANCE
WARNING:
Before inspecting, cleaning or servicing the machine,
lower the garage door, shut off motor, wait for all moving
parts to stop, disconnect unit from power supply, and
remove all modules. Failure to follow these instructions
can result in serious personal injury or property damage.
WARNING:
When servicing, use only identical replacement parts. Use
of any other parts could create a personal injury hazard
or cause product damage.
WARNING:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance. Loose, missing,
or damaged parts can result in death, serious personal
injury, or property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service center in order to
avoid a safety hazard.
PERIODIC MAINTENANCE SCHEDULE
Each Week Check the garage door operator, rail, brackets, door arms, track, and rollers for loose or damaged
parts. Replace or tighten as needed.
Each Month Manually open and close the garage door. If the door does not move smoothly, binds, or is out
of balance, have the garage door or door springs repaired by a qualified service person.
Test the automatic reversal system as described in the Installation section.
Every 3 Months Test the travel limits of the garage door, as described in the Operation section, and ensure it
opens and closes fully.
Check the condition of the power suppy cord and battery pack. Replace as needed.
Each Year Lubricate the garage door rollers and hinges. The garage door operator is lubricated with a
sufficient amount of lubricant for the life of the unit under normal operating conditions. Therefore,
no further lubrication of the operator is required. DO NOT ADD LUBRICANT TO TRACKS.
Unplug the garage door operator and test the battery backup. If the unit cannot run on DC power
alone, charge or replace the battery pack.