Use and Care Manual

19 - English

Fig. 25

Fig. 23

Front of

Power Head

Front of

Power Head

Nut

Bracket

Stud

Remove the tape securing the Wi-Fi antenna and raise it

to an upright position to ensure the best Wi-Fi signal.

NOTE: Ensure that the antenna is screwed into the power

head securely.

Place the sprocket onto the motor shaft with the round

side of the sprocket facing up.

Hold the rail assembly above the power head with arrow

pointing toward the front of the power head and the

garage door.

Rotate the rail assembly until the opening in the rail is

aligned with the sprocket.

Lower the end rail onto the sprocket with the channel

(open end) facing down. Slowly rotate the rail to the

correct orientation as you lower it into position.

When installed correctly, the teeth on the sprocket should

engage the rail assembly and the rail should sit flat on the

power head.

Place the brackets on top of the studs, and over the end

rail.

Place nuts onto the studs and tighten using a 7/16 in.

socket. Do not overtighten.

Wi-Fi

Antenna

Wi-Fi

Antenna

Sprocket

Fig. 24

ASSEMBLY