Troubleshooting Guide

15 — English

TROUBLESHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.

PROBLEM POSSIBLE CAUSE SOLUTION

Handle not in position. Handle locks not locked. Lock upper and lower handle locks.

Mower not starting. Start key needs to be reset.

Battery packs need to be reset.

Battery is low in charge or power supply

not connected.

Remove and reinstall start key.

Remove and reinstall battery packs.

Charge the battery or connect to power

supply.

Mower cutting grass unevenly. Lawn is rough or cutting height not set

properly.

Adjust the cutting height.

Mower not mulching properly. Wet grass clippings sticking to the

underside of the deck.

Wait until the grass dries before mowing.

Mower hard to push. High grass, rear of mower housing

and blade dragging in heavy grass, or

cutting height too low.

Raise cutting height.

Mower not bagging properly. Cutting height set too low. Raise cutting height.

Mower vibrating at higher speed. Blade is unbalanced, excessively or

unevenly worn.

Bent motor shaft.

Replace the blade.

Stop the motor, remove start key and

battery or disconnect power supply.

Inspect for damage. Have repaired by

an authorized service center before

restarting.

Motor stops while cutting. Cutting height set too low. Raise the cutting height.

PAGE 1
TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER. PROBLEM POSSIBLE CAUSE SOLUTION Handle not in position. Handle locks not locked. Lock upper and lower handle locks. Mower not starting. Start key needs to be reset. Battery packs need to be reset. Battery is low in charge or power supply not connected. Remove and reinstall start key. Remove and reinstall battery packs. Charge the battery or connect to power supply. Mower cutting grass unevenly.
PAGE 2
DÉPANNAGE SI LES PRÉSENTES SOLUTIONS NE RÉSOLVENT PAS LE PROBLÈME, CONTACTER LE CENTRE DE RÉPARATIONS AGRÉÉ. PROBLÈME CAUSE POSSIBLE SOLUTION Poignée en mauvaise position. Verrous de poignée ouverts. Fermer les verrous des poignées supérieure et inférieure. La tondeuse ne démarre pas. La clé de démarrage doivent être Retirer et réinstaller la clé de démarrage. réinitialisés. Retirer et réinstaller les blocs-piles. Les blocs-piles doivent être réinitialisés. Charger le bloc-pile.
PAGE 3
CORRECCIÓN DE PROBLEMAS SI CON ESTAS SOLUCIONES NO SE RESUELVE EL PROBLEMA, COMUNÍQUESE CON EL CONCESIONARIO DE SERVICIO AUTORIZADO DE SU PREFERENCIA. PROBLEMA CAUSA POSIBLE SOLUCIÓN El mango no está en posición. Las trabas de los mangos no están Cierre las trabas del mango superior y del cerradas. mango inferior. La podadora no enciende. Es necesario volver a configurar la llave de arranque. Es necesario volver a configurar los paquetes de baterías.