Operator`s manual

TO USE THE MITER GAUGE

See Figure 30.

The miter gauge provides greater accuracy in angled cuts.

For very close tolerances, test cuts are recommended.

There are two miter gauge grooves, one on either side of

the blade. When making a 90° cross cut, you can use either

miter gauge groove. When making a beveled cross cut (the

blade tilted in relation to the table) the miter gauge should be

located in the groove on the right so that the blade is tilted

away from the miter gauge and your hands.

The miter gauge can be turned 60° to the right or left.

 Loosen the lock knob.

 With the miter gauge in the miter gauge groove, rotate the

gauge until the desired angle is reached on the scale.

 Retighten the lock knob.

TO USE THE MITER GAUGE IN A REVERSE

POSITION

See Figure 31.

For larger workpieces, the miter gauge can be reversed in

the miter gauge grooves. It will be necessary when revers-

ing the miter gauge to clamp the workpiece to the miter

gauge body.

LOCK

KNOB

MITER

GAUGE

OPERATION

MITER

GAUGE BODY

MITER GAUGE

REVERSED

Fig. 31

Fig. 30