Use and Care Manual

ManualsBrandsRYOBI ManualsAccessories12 in. 2,300 PSI Electric Pressure Washers Surface Cleaner

12 in. Surface Cleaner Attachment

RY31012

WARNING:

To reduce the risk of injury, user must read and understand the

operator’s manual for their pressure washer before using this

accessory. To reduce the risk of injury or property damage,

spray the pressure stream in a safe direction to ensure proper

connection of all accessories before starting any cleaning proj-

ect. Only use on pressure washers operating at up to 2,300 psi

with a maximum flow rate of 1.4 gpm. Ensure compatibility

and proper fit before using this accessory. Wear eye protection

with side shields marked to comply with ANSI Z87.1. Risk of

fluid injections; do not point at people, pets, electrical devices

or the unit itself. Turn off the pressure washer, relieve the water

pres sure in the trigger handle, and lock the lock out on the

trigger handle (if one is included with your pressure washer)

before installing, changing, or adjusting accessories. For cold

water use only. For outdoor use only – store indoors. Save

these instructions. Refer to them frequently and use them to

instruct other users. If you loan someone this tool, loan them

these instructions also.

PRODUCT SPECIFICATIONS

Connections .....................................1/4 in. Quick Connect Plug

Deck Width ......................................................................... 12 in.

Maximum Pressure .............................................. up to 2,300 psi

Maximum Water Flow .................................................... 1.4 gpm

Maximum Inlet Water Temperature ................................... 140°F

INSTALLING THE SURFACE CLEANER ON

THE SPRAY WAND

See Figure 1.

n Pull back the quick-connect collar on the pressure washer

spray wand.

n Insert the surface cleaner inlet plug into the spray wand quick

connect coupler.

n Push the collar forward so that the surface cleaner inlet plug is

secured properly. Check to see that the connection is secure.

WARNING:

To reduce the risk of injection or injury, only use the surface

cleaner on flat, horizontal surfaces. Never lift the surface

cleaner from the cleaning surface while operating the pres-

sure washer.

USING THE SURFACE CLEANER

See Figure 2.

WARNING:

Do not reach hands or feet under cleaning deck. Contact with

the spinning nozzles or spray bar can result in a fluid injection

or other serious personal injury.

Fig. 1

INLET

PLUG

QUICK CONNECT

COUPLER

Fig. 2

n Once the surface cleaner is installed, connect the hose to the

pressure washer as described in your pressure washer manual.

n Start the pressure washer as described in your pressure

washer manual.

n Walk slowly behind the cleaning deck, cleaning as you go.

NOTE: If striping or swirling occurs, slow your pace. If strip-

ing or swirling continues, the surface cleaner nozzle(s) may

be clogged. See Nozzle Maintenance for how to clean the

nozzles.

Summary of content (6 pages)

PAGE 1
2 in. Surface Cleaner Attachment RY31012 WARNING: To reduce the risk of injury, user must read and understand the operator’s manual for their pressure washer before using this accessory. To reduce the risk of injury or property damage, spray the pressure stream in a safe direction to ensure proper connection of all accessories before starting any cleaning project. Only use on pressure washers operating at up to 2,300 psi with a maximum flow rate of 1.4 gpm.
PAGE 2
WARNING: Do not use the surface cleaner on raised obstacles. Striking any raised obstacle while using the surface cleaner could damage the unit. If contact does occur and results in damage or vibration when operating the pressure washer, stop and discontinue use. Continuing to operate a damaged unit could result in serious personal injury. BRUSH SKIRT NOZZLE MAINTENANCE See Figure 3.
PAGE 3
Accessoire de 304,8 mm (12 po) pour nettoyeur de surface RY31012 AVERTISSEMENT : Pour réduire les risques de blessure, l’utilisateur doit lire et comprendre le manuel d’utilisation de sa laveuse à pression avant de l’utiliser. Pour réduire les risques de blessures ou de dommages matériels, diriger le jet dans une direction sécuritaire pour vérifier que tous les accessoires sont bien branchés avant de commencer le nettoyage.
PAGE 4
AVERTISSEMENT : Ne pas utiliser le nettoyeur de surface sur des obstacles surélevés. Si le nettoyeur de surface heurte un obstacle surélevé, l’unité risque d’être endommagée. Si un tel contact se produit et entraîner des dommages o vibrations au moment d’employer la laveuse à pression, arrêter l’appareil et cesser l’utilisation. Poursuivre cette utilisation un unité endommagée peut entraîner des blessures graves. JUPE DE LA BROSSE ENTRETIEN DE LA BUSE Voir la figure 3.
PAGE 5
Accesorio para limpiador de superficie de 304,8 mm (12 pulg.) RY31012 ADVERTENCIA: Para reducir el riesgo de lesiones, el usuario debe leer y comprender el manual del operador de la lavadora de presión antes de usar este accesorio. Para reducir el riesgo de lesiones o daños a la propiedad, rocíe el chorro de presión en una dirección segura para asegurar que la conexión de todos los accesorios sea correcta antes de utilizar la unidad.
PAGE 6
ADVERTENCIA: No utilice el limpiador de superficies en obstáculos elevados. Golpear cualquier obstáculo por sobre el nivel del piso con la unidad de limpieza dañará la unidad. Si hay contacto y dañarse la unidad o causa vibración al operar la lavadora de presión, deténgala y suspenda su uso. Continuar operando la unidad dañado puede causar lesiones serias. CEPILLO MANTENIMIENTO DE LAS BOQUILAS GANCHO EN U Vea la figura 3.