Owner manual

1
3
4
5
9
NOTICE
Do not use E15 or E85 fuel (or fuel containing greater than 10% ethanol) in this product. It is a violation of federal law and will damage the unit and void your warranty.
HALF
CHOKE
10x
8
6
7
PRESS and HOLD switch until engine stops
To Stop:
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with 1 gallon of fresh gasoline in separate gas container. Shake. Pour into fuel tank.
GAS
PRIME press the primer bulb 10 times.
PULL starter grip and rope (4 times) until engine attempts to start.
2.6
oz.
SET choke lever to FULL position.
Do not squeeze throttle trigger.
Lay the TRIMMER on a flat, bare surface.
Squeeze throttle trigger lock and throttle trigger.
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for reading the operator’s manual. To reduce the risk of injury, user must read and understand operator’s manual before using this product.
990000802
10-22-13 (REV:01)
For any questions about operating or maintaining your product, call the Ryobi
®
Help Line!
Your Product has been fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
For additional registration instruction, refer to operator’s manual.
C
A
LL
1-800-860-4050
www.ryobitools.com
4
1
2
3
5
6
SET choke lever to HALF position.
7 8
9
PULL starter grip and rope until engine starts (6 times max.).
After 10 seconds,
SET choke lever to RUN position.