Troubleshooting Guide

ManualsBrandsRyobi ManualsLawn Mowers20 in. 40-Volt Brushless Lithium-Ion Cordless Self-Propelled Walk Behind Mower - Two 5.0 Ah Batteries/Charger Included

13 — English

TROUBLESHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.

PROBLEM POSSIBLE CAUSE SOLUTION

Handle not in position. Handle adjustment knobs and/or handle

lock clips are not secured.

Make sure handle adjustment knobs

are fully seated and handle lock clips

are fully closed.

Mower not starting. Battery is low in charge.

Start key not installed.

Handle assembly is not in operating

position.

Charge the battery.

Install start key.

Raise lower and upper handle.

Mower cutting grass unevenly. Lawn is rough or cutting height not set

properly.

Adjust the cutting height.

Mower not mulching properly. Wet grass clippings sticking to the un-

derside of the deck.

Wait until the grass dries before mowing.

Mower hard to push. High grass, rear of mower housing and

blade dragging in heavy grass, or cut-

ting height too low.

Raise cutting height.

Mower not bagging properly. Cutting height set too low. Raise cutting height.

Mower vibrating at higher speed. Blade is unbalanced, excessively or

unevenly worn.

Bent motor shaft.

Replace the blade.

Stop the motor, remove start key and

battery. Inspect for damage. Have re-

paired by an authorized service center

before restarting.

Motor stops while cutting. Cutting height set too low. Raise the cutting height.

MAKE THE MOST OF YOUR PURCHASE!

Go to http://register.ryobitools.com and register your new tool on-line.

Your product has been fully tested prior to shipment

to ensure your complete satisfaction.

For any questions about operating or maintaining

your product, call the Ryobi Help Line!

Summary of content (3 pages)

PAGE 1
TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER. PROBLEM POSSIBLE CAUSE SOLUTION Handle not in position. Handle adjustment knobs and/or handle Make sure handle adjustment knobs lock clips are not secured. are fully seated and handle lock clips are fully closed. Mower not starting. Battery is low in charge. Charge the battery. Start key not installed. Install start key. Handle assembly is not in operating Raise lower and upper handle. position.
PAGE 2
DÉPANNAGE SI LES PRÉSENTES SOLUTIONS NE RÉSOLVENT PAS LE PROBLÈME, CONTACTER LE CENTRE DE RÉPARATIONS AGRÉÉ. PROBLÈME CAUSE POSSIBLE SOLUTION Poignée en mauvaise position. Les boutons de réglage de la poignée S’assurer que les boutons de réglage de et/ou les pinces de blocage de la la poignée sont complètement assis et poignée ne sont pas fixés correctement. que les pinces de blocage de la poignée sont correctement fermées. La tondeuse ne démarre pas. La pile est basse dans la charge.
PAGE 3
CORRECCIÓN DE PROBLEMAS SI CON ESTAS SOLUCIONES NO SE RESUELVE EL PROBLEMA, COMUNÍQUESE CON EL CONCESIONARIO DE SERVICIO AUTORIZADO DE SU PREFERENCIA. PROBLEMA CAUSA POSIBLE SOLUCIÓN El mango no está en posición. Las perillas de ajuste del mango y/o las Asegúrese de que las perillas de ajuste trabas del mango no están trabadas. del mango y las trabas del mango estén completamente asentados. La podadora no enciende. La batería es baja en la carga. Cargue la batería.