Use and Care Manual

ManualsBrandsRyobi ManualsOutdoor Power Combo Kits40-Volt Lithium-Ion Cordless Hedge Trimmer and Brushless Chainsaw Combo Kit (2-Tool) - 2.6 Ah Battery & Charger Included

15 - English

Before each use, inspect the entire product for

damaged, missing, or loose parts such as screws,

nuts, bolts, caps, etc. Tighten securely all fasteners

and caps and do not operate this product until all

missing or damaged parts are replaced. Please call

1-800-860-4050 or contact an authorized service

center for assistance.

APPLICATIONS

You may use this product for the following purposes:

Limbing and pruning branches from trees

Felling small trees

Bucking the fallen tree into shorter lengths

This product will accept Ryobi 40 V lithium-ion

battery packs.

For complete charging instructions, refer to the

Operator’s Manual for your Ryobi 40 V battery

pack and charger model.

TO INSTALL/REMOVE BATTERY PACK

See Figure 5.

WARNING:

Always remove battery pack from your tool

when you are assembling parts, making

adjustments, cleaning, carrying, transporting

or when not in use. Removing battery pack will

prevent accidental starting that could cause

serious personal injury.

NOTE: To avoid serious personal injury, always

remove the battery pack and keep hands clear of

the look-out button when carrying or transporting

the tool.

To install:

 Place the battery pack in your chain saw. Align

raised rib on battery pack with groove in chain

saw’s battery port.

 Make sure the latch on bottom side of the

battery pack snaps in place and that battery

pack is secured in chain saw before beginning

operation.

To remove:

Locate latch on bottom of battery pack and depress

both sides to release the battery pack from the

chain saw.

OPERATION

NOTICE:

When placing battery pack in your chain saw,

be sure raised rib on battery pack aligns with

groove in chain saw’s battery port and latches

snap in place properly. Improper assembly of

battery pack can cause damage to internal

components.

NOTICE:

Remove battery pack from unit. Fill oil tank with

bar and chain lubricant (not provided) before

starting the chain saw. Failure to lubricate the

chain will cause damage to the bar and chain.

Fig. 6

Fig. 5

BATTERY

PACK

LATCH

BATTERY

PORT