Use and Care Manual

13 — English
WARNING:
Before performing any adjustment, make sure the tool is
unplugged from the power supply and the switch is in the
OFF position. Failure to heed this warning could result in
serious personal injury.
The saw has been adjusted at the factory for making very
accurate cuts. However, some of the components might
have been jarred out of alignment during shipping. Also,
over a period of time, readjustment will probably become
necessary due to wear.
Do not start any adjustments until you have checked with
a square and made test cuts to be sure adjustments are
needed.
TO SQUARE THE CUTTING WHEEL TO THE
TABLE
See Figure 30, page 22.
Do not loosen any screws for this adjustment until you have
checked with a square and made test cuts to be sure adjust-
ments are necessary. Once the screws are loosened, these
items must be reset.
 Unplug the saw.
ADJUSTMENTS
 Using a 13 mm wrench or adjustable wrench (not in-
cluded), loosen the hex bolt at the front of the frame and
end of the slide rod.
 Move the table with slide rod until the fence is square
with the cutting wheel.
 Tighten the hex bolt securely.
TO ADJUST THE TABLE ROLLERS
See Figure 31, page 23.
If the table doesn’t slide smoothly, seems too loose on
the slide rod, or moves side to side, adjustments may be
required.
 Loosen the nut on the end of the cam bolt.
 Insert 3 mm hex key (not included) into the end of the
cam bolt and adjust bolt as needed.
 Once the rollers are touching the rail, tighten the cam bolt
nut securely. Repeat for each roller as required.
NOTE: Check that rollers are rolling properly after each
adjustment.