Installation Guide

INSTALLATION INSTRUCTIONS

MANHATTAN

BRIDGE / DRAWER

BR-MANHATTAN-12xx

THANK YOU FOR CHOOSING XYLEM

ROUGH-IN DIMENSIONS

SUGGESTED TOOLS AND MATERIALS

sessalG ytefaS erusaeM epaTllirDleveL revirdwercS spilihP

10'

12” (305mm)

22" (559mm)

24" (610mm)

INSTALLATION INSTRUCTIONS

Please take a few minutes to review this manual before you start installation. If you encounter any

installation problems, please don’t hesitate to contact us. Before you begin, please observe all local

building codes. Unpack the new product and inspect for damage. The appearance of your vanity may

differ from the illustrations in this guide. This instructions still apply. Please ensure the finished wall is

straight and plumb and the floor is flat and perpendicular to the finished wall.`

2x6 backing

material

PAGE 1
INSTALLATION INSTRUCTIONS TM MANHATTAN TM BRIDGE / DRAWER BR-MANHATTAN-12xx THANK YOU FOR CHOOSING XYLEM Please take a few minutes to review this manual before you start installation. If you encounter any installation problems, please don’t hesitate to contact us. Before you begin, please observe all local building codes. Unpack the new product and inspect for damage. The appearance of your vanity may differ from the illustrations in this guide. This instructions still apply.
PAGE 2
. 3. CARE AND CLEANING • To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid extreme changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units. Avoid placing furniture directly under windows. • Dust the vanity frequently with a clean, soft, dry or lint-free cloth. Clean the surface by rubbing in the direction of the grain using damp lint-free cloth.
PAGE 3
REMOVE / ADJUST THE DRAWER Note: The height adjustment spinner and quick-release latch are located under the front front of the drawer at each corner. To Remove Drawer: • Slide the drawer out until it is fully extended. • Pull both the quick release latch inwards and lift the drawer out of the vanity. To Adjust the Drawer: • Slide the drawer out until it is fully extended. • Pull both the quick release latch inwards and lift the drawer out of the vanity.