Instructions / Assembly

SUGGESTED TOOLS AND MATERIALS

Phillips Screwdriver Silicon Sealant Tape Measure Safety Glasses

PARTS / HARDWARE INCLUDED

500001

111213

111214

SINK INSTALLATION

120003

BEFORE YOU BEGIN

INSTALLATION INSTRUCTIONS

UNDERMOUNT SINK

All Models

CUM-XXXX

08.2014

For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax 866.395.8113 any time

• Observe all local plumbing and building codes.

• Follow these instructions only if it applies to your installation.

• Before installation, carefully inspect it for damage. Return the vanity top to its packaging until you are ready to install it.

• These instructions contain important care and cleaning instructions. Please review these instructions carefully.

CAUTION! Risk of product damage. Do not use plumbers putty or oil-based sealers with

this vanity top. These products will stain surfaces permanently.

Apply a continuous bead of quality sealant to the

surface (rim) of the sink.

Turn the vanity upside down and place it on a clean,

scratch-resistant surface. Center the sink over the cutout.

Secure the sink to the top using the mounting kit / hardware provided.

**NOTE: Sink style, shape, and cutout on top may vary from the picture above. Instructional purposes only.

PAGE 1
INSTALLATION INSTRUCTIONS UNDERMOUNT SINK All Models CUM-XXXX BEFORE YOU BEGIN • • • • Observe all local plumbing and building codes. Follow these instructions only if it applies to your installation. Before installation, carefully inspect it for damage. Return the vanity top to its packaging until you are ready to install it. These instructions contain important care and cleaning instructions. Please review these instructions carefully.
PAGE 2
CARE AND CLEANING • Never use a strong / abrasive cleaner. Always test your cleaning solution on an unnoticeable area before applying it to the entire surface. • Wipe surfaces clean, immediately after applying cleaner. • Do not allow the cleaner to sit or soak. Never let cleaners sit on the surface of the lavatory. • Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to clean surfaces. They will scratch the lavatory surface.