Owner's manual

08.2014

For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax 866.395.8113 any time

INSTALLATION INSTRUCTIONS

MALAGO

VANITY

V-MALAGO-XXDM

SUGGESTED TOOLS AND MATERIALS

Phillips Screwdriver Level Drill Tape Measure Safety Glasses

10'

THANK YOU FOR CHOOSING RYVYR

Please take a few minutes to review this manual before you start installation. If you encounter

any installation problems, please don’t hesitate to contact us. Before you begin, please

observe all local building codes. Unpack the new product and inspect for damage. The

appearance of your vanity may differ from the illustrations in this guide. These instructions

still apply. Please ensure the finished wall is straight and plumb and the floor is flat and

perpendicular to the finished wall.

ROUGH-IN DIMENSIONS

supply

holes

Xmm [Y"]

Model # Width

V-MALAGO-24DM x = 610mm [24"]

V-MALAGO-30DM x = 762mm [30"]

V-MALAGO-36DM x = 914mm [36"]

PAGE 1
INSTALLATION INSTRUCTIONS MALAGO TM VANITY V-MALAGO-XXDM THANK YOU FOR CHOOSING RYVYR Please take a few minutes to review this manual before you start installation. If you encounter any installation problems, please don’t hesitate to contact us. Before you begin, please observe all local building codes. Unpack the new product and inspect for damage. The appearance of your vanity may differ from the illustrations in this guide. These instructions still apply.
PAGE 2
INSTALLATION INSTRUCTIONS • Position the vanity against the finished wall. If necessary, turn the leg levelers to achieve level. • Mark the supply and drain locations on the inside of the vanity back wall. • Move the vanity away from the wall and cut the marked supply and drain locations from inside. • Position the vanity against the wall, aligning the supply and drain locations with the cut holes. • Install the counter top, sink, drain and faucet according to the manufacturer’s instructions.