PV Kit 2.0 Edge Manual

ManualsBrandsS-5 ManualsHardwareS-5! EdgeGrab PV Kit 2.0 Edge

3. Install the rst row of modules (Fig 3a): Place rst module

in the grabs pushing on the frame to seat the module against

the EdgeGrabs and Module Placement Bevel Guide (Fig 3b).

Drive the Low Prole Bolt with the provided hex bit to tighten

the grabs (Fig 3c). Low Prole Bolt and Stando should be

torqued to 120-130 in lbs (13.6-14.7 Nm). Check torque

periodically with Calibrated Dial Torque Wrench.

Note: PV Kit 2.0 ts

module frame

thicknesses from

33 mm-46 mm

4. Install MidGrab/StandO Assembly & PV Disk on Clamps:

the PV Disk and MidGrab/StandO Assembly should be

mounted to the clamps before mounting the clamps to the

roof. Place the PV Disk atop the clamp and thread the male

portion of the StandO through the disk and into the clamp.

Drive the MidGrab/StandO Assembly down with the provided

bit tip (Fig 4) in similar fashion to Step 2. Note: When using

the S-5-H90 or S-5-K Grip style clamps, the clamp must be

secured to the roof prior to xing the S-5-PV Kit 2.0 EdgeGrab

or MidGrab assembly to clamps. See: Tips for Mounting with

CorruBrackets, S-5-H90, or S-5 K Grip Style Clamps at end of

installation instructions.

5. Place MidGrab/StandO/Disk & Clamp Assemblies: using

the PV module as a guide, place the throat of the clamp over

the seam and slide the assembly into place so that the edge

of the module is seated against the wall of the MidGrab and

the Module Placement Bevel Guide, similar to (Fig 3b). Tighten

the setscrew(s) of the clamp as described in step 1. The grabs

should be left in the partially open position to accommodate

the next row of modules before nal tightening.

6. Install Additional PV Modules-repeating steps 3-5: place

another module in the MidGrabs that were left open in the

previous step. Tighten the downslope row of grabs each time

a module is placed and leave the upslope open until the next

module is placed (Fig. 6). The nal row will be nished with

EdgeGrab/StandO Assemblies. Periodically look back at the

modules you’ve installed to double check that the MidGrabs

were tightened.

PV Kit 2.0 Installation Instructions

S-5!® Warning! Please use this product responsibly!

Products are protected by multiple U.S. and foreign patents. For published data regarding holding strength, fastener torque, patents, and trademarks, visit the S-5! website at www. S-5.com.

3a.

3b. 3c.