S-5-H90 install

To Install the S-5-H90 Mini
4. For critical attachment
applications, tighten the M8-1.25 X 16 mm
Hex Flange Bolt (sold seperately) to 160 inch pounds
(13 foot pounds).
S-5-H90 Mini Installation Instructions
Specified Torque Inch Pounds Foot Pounds Nm
22ga steel 160–180 13–15 18–20
24ga steel and
all other metals
130–150 11–12.5 15–17
Once installed correctly, these clamps require no maintenance or re-
inspection for the life of the roof.
1. Partially thread the setscrew into the clamp by hand.
2. Turning the clamp so that the bolt hole side is facing up, slip the clamp on
the horizontal portion of the seam.
3. Tighten the setscrew using a screw gun* and the included screw gun bit tip.
The setscrew will dimple the seam material but will not penetrate it. When
relying on published load values, setscrew tension should be verified
periodically using a calibrated torque wrench as indicated below to ensure
the tool is consistently achieving the proper torque range.
*For time-saving tool recommendations, call S-5!
2
4
3
1
S-5!® Warning! Please use this product responsibly!
Products are protected by multiple U.S. and foreign patents. Visit the website at www.S-5.com for complete information on patents and trademarks. For maximum holding strength,
setscrews should be tensioned and re-tensioned as the seam material compresses
torque.
other metals and thinner gauges of steel. Consult the S-5! website at www.S-5.com for published data regarding holding strength.
Copyright 2020, Metal Roof Innovations, Ltd. S-5! products are patent protected.
S-5! aggressively protects its patents, trademarks, and copyrights. Version 0420.
H90I-V1.1-0420
NOTE: Any S-5! warranty and/or calculation may be void if hardware
is used that was not furnished by S-5! directly or through one of their
licensed distributors