S-5-N and Installation Manual
S-5-N and S-5-N Mini Installation Instructions
S-5!® Warning! Please use this product responsibly!
Products are protected by multiple U.S. and foreign patents. For published data regarding holding strength, fastener torque, patents, and trademarks, visit the S-5! website at www.
S-5.com. Copyright 2020, Metal Roof Innovations, Ltd. S-5! products are patent protected. S-5! aggressively protects its patents, trademarks, and copyrights.
NNmini-V1.2-0420
3. The clamp should be over the seam and insert as
shown. (Fig 3a) Make sure the toe of the clamp
engages the female part of the seam as shown.
(Fig 3b)
4. Tighten the setscrew(s) using a screw gun* and the
included bit tip (Fig 4). When relying on published
load values, setscrew tension should be veried
periodically using a dial-indicating calibrated
torque wrench to ensure the tool is consistently
achieving the recommended torque range (Table
1).
3a.
4.
3b.
* For time-saving tool recommendations, call S-5!
Note: Seams that exceed maximum allowance of 0.82” at
the widest part of the seam may require hand crimping to
facilitate clamp t. (Fig 5)
5.
Units in inches
Table 1
Only if installing the Standard-sized Clamp:
- Setscrews should be tensioned and re-tensioned
as the seam material compresses, (i.e. tighten the
rst setscrew, then the second; then repeat).
When installing the Mini-sized clamp:
- The seam material will compress evenly the rst
tightening.
NOTE: S-5-N packages with a M8-1.25 X 16mm hex flange bolt
included. S-5-N Mini does not package with a top bolt and may need
to be purchased separately for certain applications. For critical
attachment applications utilizing an M8-1.25 X 16 mm hex flange
bolt, tighten the M8 bolt to 160 inch pounds (13 foot pounds). Any
S-5! warranty and/or calculation may be void if hardware is used that
was not furnished by S-5! directly or through one of their licensed
distributors