Installation

ManualsBrandsS-5! ManualsSolar & Wind PowerClamp for 1.5" Nail Strip Metal Roof Profiles

The right way to attach almost anything to metal roofs!

888-825-3432 www.S-5.com

S-5-NH 1.5 & S-5-NH 1.5 Mini Install Instructions

S-5!® Warning! Please use these products responsibly! Visit our

website or contact your S-5! distributor for available load test

results.

IMPORTANT NOTICE to S-5! users: Due to the many variables

involved with speciﬁc panel products and job particulars, -the

manufacturer cannot and does not express any opinions as to the

suitability of any S-5! assembly for any speciﬁc application and

assumes no liability with respect thereto.

S-5! products are tested for ultimate holding strength on various

proﬁle types, materials, and brands of manufacture. This information

is available from the S-5! website: www.S-5.com. This document is an

installation guide only and the photographs and drawings herein are

for the purpose of illustrating installation, tools and techniques, not

system designs. Information contained within is intended to apply to

the document as a whole.

The S-5-NH 1.5 and S-5-NH 1.5 Mini are designed to ﬁt numerous (but

dimensionally speciﬁc) 1.5” nail strip proﬁles. These proﬁle types are

vast with new variations coming into the market regularly. These clamps

may not be suitable for every such proﬁle. To avoid potential damage

to roof seam it is important to verify clamp-to-roof suitability prior to

installation. Consult the S-5! load table for suitability.

These instructions are for use by those experienced in the trade. Always follow appropriate safety precautions and use appropriate tools.

Installation Instructions

Tools Needed

To Install S-5-NH 1.5 and

S-5-NH 1.5 Mini

1. Load the setscrew(s) and insert into the clamp.

(Fig 1). Insert is reversible, this allows the clamps

top surface to sit level to the roof surface on various

seam widths.

2. Position clamp and insert at desired location along

the seam as shown. (Figs 2,3)

• Screw Gun*

• T-30 Torx Bit Tip (provided)

• Dial-Calibrated Torque Wrench

(For accurate tension values, do NOT use a clicking torque

wrench).

Components

0.9” Round Point

T-30 Torx

Setscrew

Clamp body

Hinged Insert

(Reversible to t

a range of seam

widths)

Summary of content (2 pages)

PAGE 1
S-5!® Warning! Please use these products responsibly! Visit our website or contact your S-5! distributor for available load test results. IMPORTANT NOTICE to S-5! users: Due to the many variables involved with speciﬁc panel products and job particulars, -the manufacturer cannot and does not express any opinions as to the suitability of any S-5! assembly for any speciﬁc application and assumes no liability with respect thereto. 0.
PAGE 2
S-5-NH 1.5 and S-5-NH 1.5 Mini Installation Instructions 3. The clamp should be over the seam with the insert engaging opposite the open side of the seam as shown. (Fig 3a) Make sure the toe of the clamp engages the female part of the seam. (Fig 3b) 4. Tighten the setscrew(s) using a screw gun* and the included bit tip (Fig 4).