Installation
S-5-NH 1.5 and S-5-NH 1.5 Mini Installation Instructions
S-5!® Warning! Please use this product responsibly!
Products are protected by multiple U.S. and foreign patents. For published data regarding holding strength, fastener torque, patents, and trademarks, visit the S-5! website at www. S-5.com.
Copyright 2020, Metal Roof Innovations, Ltd. S-5! products are patent protected. S-5! aggressively protects its patents, trademarks, and copyrights.
NH15-V1.1-0920
3. The clamp should be over the seam with the insert
engaging opposite the open side of the seam as
shown. (Fig 3a) Make sure the toe of the clamp
engages the female part of the seam. (Fig 3b)
4. Tighten the setscrew(s) using a screw gun* and the
included bit tip (Fig 4). When relying on published
load values, setscrew tension should be veried
periodically using a dial-indicating calibrated
torque wrench to ensure the tool is consistently
achieving the recommended torque range
(Table 1).
* For time-saving tool recommendations, call S-5!
Table 1
Only if installing the Standard-sized Clamp:
Setscrews should be tensioned and re-tensioned as
the seam material compresses, (i.e. tighten the rst
setscrew, then the second; then repeat).
Note: S-5-NH 1.5 packages with a M8-1.25 X 16mm hex
ange bolt included. S-5-NH 1.5 Mini does not package
with a top bolt and may need to be purchased separately
for certain applications.
For critical attachment applications utilizing an M8-1.25
X 16 mm hex ange bolt, tighten the M8 bolt to 160
inch pounds (13 foot pounds). Any S-5! warranty and/or
calculation may be void if hardware is used that was not
furnished by S-5! directly or through a licensed distributor.
3a.
3b.
4.
5.
Note: After setscrew(s) are torqued
the insert will “form” to the seam
similarly to as shown in (Fig 6). This
allows the insert to better engage
with a variety of seams.
6.