PVKIT 2.0 Brochure Sheet

The right way to attach almost anything to metal roofs!

PVKIT 2.0 Features:

Pre-assembled kit saves time and money

Only one tool needed for installation

Bolt head uses standard hex bit tip

which is provided

Improved single piece EdgeGrab installs

with ease

Low profile bolt head provides a sleek and clean finish

Also available in black by special order only

MidGrab leaves 1" gap between modules, allowing

reduction per ASCE7

UL 2703 Listed

The concept of combining photovoltaic arrays with standing seam metal roong is growing—and

for good reasons. A standing seam metal roof has a life expectancy consistent with that of framed PV

modules—a 30-year power source on a 40-year roof, along with zero-penetration technology, creates

the most sustainable roof system available with alternative power generation, all without compromising

the roof manufacturer's warranty! PVKIT® 2.0 is also a great solution for attaching PV modules directly to

many exposed fastener roofs when paired with S-5! brackets.

S-5! has introduced a new and improved PVKIT, boasting an improved installation experience for PV

mounting technology. The kit comes preassembled with either the MidGrab or EdgeGrab for easier and

more ecient installation. The kits were designed with thread lock on the stando bolt so that the grab

will seat to the PV Module frame by using one tool to drive the top bolt, eliminating a step required in

the previous PVKIT. The PVKIT 2.0 features bonding teeth, which are more aggressive to secure a better

ground path. No lugs or wire required except to connect one string of modules to another and to ground

the system.

The S-5 PVKIT 2.0 is built to save you time and money —

The Right Way® to install solar to your metal roof.

PVKIT 2.0 EdgeGrab Assembly

888-825-3432 | www.S-5.com |

PVKIT® 2.0 MidGrab or EdgeGrab

PAGE 1
for good reasons. A standing seam metal roof has a life expectancy consistent with that of framed PV modules—a 30-year power source on a 40-year roof, along with zero-penetration technology, creates the most sustainable roof system available with alternative power generation, all without compromising many exposed fastener roofs when paired with S-5! brackets. S-5! has introduced a new and improved PVKIT, boasting an improved installation experience for PV mounting technology.
PAGE 2
PVKIT 2.0 MidGrab Assembly PVKIT® 2.0: New Design The PVKIT 2.0 is furnished with the hardware shown at right, excluding the attachment clamp, which is supplied separately. The PVKIT 2.0 is compatible with most common metal roofing materials, including copper. PVKIT 2.0 EdgeGrab The Module Placement Bevel Guide makes the module placement easier. The mounting disk is multi-directional and rails are not required.