User's Manual

INTRODUCTION
Qualified Persons
Read this Instruction
Sheet
Retain this
Instruction Sheet
Latest Document
Release
Warranty
 WARNING
The equipment covered by this publication must be installed, operated, and maintained b
y
qualified persons who are knowledgeable in the installation, operation, and maintenance of local
area networking and routing functions along with the associated hazards. A qualified person is
one who is trained and competent in:
• Radio technicians must be qualified to install transmission power limited radio equipment,
per FCC Part 15.
• The skills and techniques necessary to distinguish exposed live parts from non-live parts o
f
electrical equipment.
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed.
• The proper use of the special precautionary techniques, personal protective equipment,
insulating and shielding materials, and insulated tools for working on or near expose
d
energized parts of electrical equipment.
These instructions are intended only for such qualified persons. They are not intended to be
a
substitute for adequate training and experience in safety procedures for this type of equipment.
Thoroughly and carefully read this instruction sheet before programming, operating, o
r
maintaining your S&C SpeedNet Radios. Familiarize yourself with the safety information on page
3.
This instruction sheet is a permanent part of your S&C SpeedNet Radio. Designate a location
where you can easily retrieve and refer to this publication. This documentation is also available a
t
the S&C website: www.sandc.com.
The latest release of this instruction sheet is available online at www.sandc.com. Select:
Support/Product Support Documents. Documents are posted in PDF format.
The standard warranty contained in S&C's standard conditions of sale, as set forth in Price Shee
t
150, applies to the S&C SpeedNet Radio, except that the first paragraph of said warranty is
replaced by the following:
(1) General: Seller warrants to immediate purchaser or end user for a period of 10 years from the
date of shipment that the equipment delivered will be of the kind and quality specified in the
contract description and will be free of defects of workmanship and material. Should any failure to
conform to this warranty appear under proper and normal use within ten years after the date o
f
shipment the seller agrees, upon prompt notification thereof and confirmation that the equipmen
t
has been stored, installed, operated, inspected, and maintained in accordance wit
h
recommendations of the seller and standard industry practice, to correct the nonconformity eithe
r
b
y repairing any damaged or defective parts of the equipment or (at seller's option) by shipment o
f
necessary replacement parts. The seller's warranty does not apply to any equipment that has bee
n
disassembled, repaired, or altered by anyone other than the seller. This limited warranty is grante
d
only to the immediate purchaser or, if the equipment is purchased by a third party for installation
in third-
p
arty equipment, the end user of the equipment. The seller's duty to perform under any
warranty may be delayed, at the seller's sole option, until the seller has been paid in full for all
goods purchased by the immediate purchaser. No such delay shall extend the warranty period.
Replacement parts provided by seller or repairs performed by seller under the warranty fo
r
the original equipment will be covered by the above special warranty provision for its duration.
Replacement parts purchased separately will be covered by the above special warranty provision.
1072-510
2