User Manual
6 S&C Form 974
Connect to a TripSaver II Controller Module
To connect to a TripSaver II controller module to apply your
new settings, follow these steps:
STEP 1. Install the USB Transceiver.
A USB transceiver must be installed on your computer to
communicate with a TripSaver II controller module. Insert
the USB transceiver into any USB port on your computer.
See Figure 1. The installation process should be automatic.
Note: You do not need the USB transceiver to be installed to
install the software and to run the software in Standalone
(ofine) mode.
STEP 2. Assemble the power supply and power up the
TripSaver II controller module.
A TripSaver II controller module must be powered by the
power module to enable its communication capability.
Complete the following steps before attempting to
communicate with your TripSaver II controller module:
(a) Insert the connector from the power module onto the
pins in the TripSaver II controller module, as shown in
Figure 2.
(b) Install the proper power outlet plug adapter onto the ac
adapter. See Figure 3.
(c) Plug the ac adapter into a wall outlet. See Figure 4.
Figure 1. Insert the USB transceiver.
Figure 2. Insert the connector from the power module.
Figure 3. Insert power outlet plug adapter.
Figure 4. Plug the adapter into a wall outlet.