User's Manual

14 S&C Instruction Sheet 1069-500
FCC Radiation Exposure Statement
To ensure compliance with the FCC’s RF expo-
sure limits, the antenna used for this transmitter
must be installed to provide a separation distance
from all personnel. The distance must be 76 cm.
The transmitter must not be co-located or op-
erated in conjunction with any other antenna or
transmitter. Installers and end users must follow
these installation instructions.
Canadian Compliance Statement
This Class A Digital apparatus meets all the re-
quirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numerique de la classe A respecte
les exigences du Reglement sur le material broil-
leur du Canada.
This device complies with Class A Limits of In-
dustry Canada. Operation is subject to the follow-
ing two conditions:
1. This device may not cause harmful interfer-
ence, and
2. This device must accept any interference re-
ceived, including interference that may cause un-
desired operation.
S&C IntelliCom WAN Mesh Radios wireless mesh
radios are certified to the requirements of RSS-
210 for 2.4 and 5 GHz spread spectrum devices.
The use of this device in a system operating either
partially or completely outdoors may require the
user to obtain a license for the system according
to the Canadian regulations. For further informa-
tion, contact your local Industry Canada office.
Canadian units will not transmit in the 5600-5650
MHz band.
DFS Notice
S&C IntelliCom WAN Mesh Radio devices are
subject to Section 15.407 of FCC rules and are
required to implement radar detection and DFS
functions. They are DFS-certified, and will not
transmit on channels which overlap the 5600 –
5650 MHz band (channels 120, 124, 128).
Devices intended for outdoor use are further re-
stricted, as follows:
Any installation of a device within 35 km of a Ter-
minal Doppler Weather Radar (TDWR) location
shall be separated by at least 30 MHz (center-to-
center) from all TDWR operating frequencies (as
shown in Table 5.3).
Procedures for the installers and the operators on
how to register the devices in the industry-spon-
sored database with the appropriate information
regarding the location and operation of the device
and installer information is included.
Typical DFS Settings for Maximum Tx
Power
This table is based on a 2.5m LMR400 coaxial
cable, which has a 0.9 ± 0.2 dB loss.
Antenna Gain Maximum Tx Power Setting
19 dBi 7 dBm
16 dBi 10 dBm
9 dBi 17 dBm
Appendix B: Regulatory