User's Manual

4 S&C Instruction Sheet 1069-500
Package Contents
Your S&C IntelliCom WAN Mesh Radio family package contains
the items shown in Table 2.1.
Item 1720
Qty
1710
Qty
Warranty & registration card 1 1
CD with Software; Reference Guide; Hardware Installation Guide; EULA 1 1
2.4/5 GHz dual-band omni antennas, detachable 6 2
S&C IntelliCom WAN Mesh Radio family 1
N to reverse-polarity SMA adapter 6
Mounting bracket for pole and wall mounting. Designed to t 37 mm to
50 mm (1.5 in to 2.0 in) poles.
1
Mounting Kit, including U-bolts, M6x1.0-80mm, with at washers,
split washers, nuts. Claw-tooth pole grippers. M6x1.0-40mm hex bolt.
M6x1.0-20mm hex bolt. Hex-head socket wrench.
1
AC power cord with NEMA 5-15 (US) plug. Other IEC cords are available
separately.
1
External power module with NEMA 5-15 (US) to IEC-320 cord. Other IEC
cords are available separately.
1
This hardware installation sheet describes how to install the
S&C IntelliCom WAN Mesh Radio safely. It is intended to be in-
stalled by trained professionals. Be sure to read and understand
all installation and safety instructions before proceeding with the
installation.
Setup & Conguration
You should set up and test your radios indoors, on a bench or
table, before installing them. This will allow you to pre-configure
the radios so that they are all on the same RF channel, etc. You
will use IntelliCom View Pro to configure the radios and create a
small mesh network. Test the network settings you plan to use.
Radio Upgrades
S&C IntelliCom WAN Mesh Radios can be configured to support
one or two radios, and the radio can optionally support 802.11n
(MIMO) operation. S&C IntelliCom 1710-DA radios do not support
802.11n.
Table 2.1 Package con-
TenTs
This table lists the
items contained in your
S&C IntelliCom WAN 1710 & 1720
kits.
Setup and Installation