User's Manual

8 S&C Instruction Sheet 1069-500
If you are not using three antennas on each radio, install antennas
in order, from the front of the unit toward the back. Do not ‘skip’
antenna connections.
Mounting Outdoor Antennas
Once you determine which RF band to use, you can order spec-
trum-specific high-gain antennas from S & C or another supplier.
Many installers prefer to mount the radio and its associated an-
tennas to a short bar, typically about 2 meters long. This entire bar
assembly is then mounted horizontally to the vertical mast of the
main antenna structure.
Mounting the S&C IntelliCom WAN 1720
You can mount the radio to a wall, a light pole, or an irregularly
shaped pole. The universal mounting bracket has been designed
with multiple holes and slots to allow mounting with bolts, straps,
or other methods. Extra nuts and bolts are provided for this pur-
pose; don’t be alarmed if you have leftover fasteners when instal-
lation is complete.
The Universal Mounting Bracket contains holes and slots to al-
low it to be mounted via U-bolts or straps. Use four screws (not
supplied) to attach the universal mounting bracket securely to the
wall using the four holes near the top and bottom of the univer-
sal mounting bracket. Use appropriate anchors when attaching to
masonry or other materials.
Figure 3.3 Mounting Bracket
Your radio shipped with a two-
piece mounting bracket as shown
in the upper photo. To mount the
radio, remove the outer piece, by
loosening the thumb screws. The
inner bracket can be left attached
to the radio, as shown in the
lower photo.
Setup and Installation