Manual

1/9/2009
REV-C
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
(Over)
75-1514-1
7. Remove the OE air box from the vehicle.
9. Install the S&B air box. Use the 1/4 bolts,
washers, nuts and tighten the box to the
inner fender.
1. Turn off engine and disconnect
negative battery terminal.
2. Remove the 1/2” crankcase vent
hose from the OE air tube.
3. Loosen the clamps on the OE air tube.
5. Remove the OE air tube and air box lid
from the vehicle. Remove the OE air filter
element.
8. Remove the OE bolt in the passenger side
core support rod near the grill at the front of
the vehicle.
4. Release the 5 clips on the OE air box.
6. Loosen the 3 nuts that secure the OE
air box to the inner fender of the vehicle.
1997-2005
Jeep Wrangler
4.0L L-6
10. Attach the 2 3/4x2 coupler to the S&B tube,
leaving the clamps semi tight for adjustment.
Install the S&B tube into the vehicle.
If Equipped: with the air temp. sensor, you will
need to drill a 3/4” hole in the S&B tube before
installing it. Use the OE tube as a guide for
proper hole placement. Install the supplied
grommet into the 3/4” hole and continue with
the installation.
11.Slide the #60 hose clamp onto the S&B
tube.
787 S. Wanamaker Ave, Ontario, CA 91761
[phone] Phone • [phone] Fax
www.sbfilters.com
12. Install the S&B filter into the S&B box.
Slide the filter onto the air tube until the
filter base contacts the air box wall. This is
a “pull thru method”.
Qty Parts List Qty Parts List Qty Parts List Qty Parts List
1 1/2" x 9” Vacuum Hose 4 #10 Screw 1 Air Box 1 5/16”
1 2-3/4" x 2” Coupler 2 1/4”-20 Bolt 1 Tube 4 #10 Washer
2 # 44 Hose Clamp 1 M8 x 40 Bolt 1 Clear Lid 4 1/4” Washer
1 Tie Bar Spacer 2 1/4”-20 Nut 1 Filter 1 grommet
Tools Required
7/16" Socket & Wrench, Flat Head Screwdriver, Phillips Head Screwdriver
2a. If Equipped: Disconnect the Air Temp.
Sensor electrical connection near the throttle
body and rotate it a 1/4 turn counterclockwise
to remove it from the tube..