User guide

12/11/2006
INSTALLATION INSTRUCTIONS
(Over)
75-1515-1
Daimler Chrysler
PT Cruiser L4-2.4L
Non Turbo
Qty Parts List Qty Parts List (continued)
1 2 3/8” - 2” Adapter 1 1/2” Grommet
1 1/2” x 7” Hose 2 3/8”-16 Hex Bolt
1 Performance Intake Kit Shield 1 1/4”-20 Hex Head Screw
1 Edge Trim 3/4” Bulb 1 1/4” Finishing Washer
1 Intake Tube 2 3/8” Washer
1 CARB Sticker 1 Saddle Clamp
1 Instruction Sheet 3 1/4” Flat Washer
2 Hose Clamp #36 1 1/4”-20 Nylock Nut
1 Hose Clamp #48 1 M6 Nylock Nut
2 Rubber Well Nut 1 M6 SS Screw
1 Angle Bracket 1 Air Filter
Tools Required
Flat Head Screwdriver
7/16” Wrench
10mm Wrench
1/8” Allen
9/16” Socket
1. With the engine off, disconnect the vehi-
cle’s negative battery cable.
2. Disconnect the air temperature sensor.
3. Pull up and remove engine cover.
4. Loosen hose clamp at throttle body.
4B. Loose hose clamp at air box. 8. Assemble U-bracket as shown below.
5. Remove the crank case vent from the
valve cover.
9. Assemble the edge trim as shown below.
6. Remove air intake and air box from
vehicle.
10. Installed the U-bracket to the heat
shield as shown below.
7. Remove the air box grommets as shown
below.
11. Install rubber well nut into air box grom-
met holes.
Performance Intake Kit
787 S. Wanamaker Ave, Ontario, CA 91761
[phone] Phone • [phone] Fax
www.sbfilters.com