Owner manual

5/23/2011
REV-B
PERFORMANCE TESTING
∗
Engage parking brake and start
your engine. To ensure that the
system was installed properly,
listen for abnormal noises. If an
air leak is detected, re-inspect
hoses and connections as they
may need to be tightened.
∗ S&B FILTERS RECOMMENDS
THAT YOU KEEP YOUR OEM
INTAKE SYSTEM IN THE
EVENT IT IS REQURIED IN THE
FUTURE.
∗ In order to maintain proper war-
ranty, all connections and com-
ponents must be checked peri-
odically for realignment and to
tighten all connections. Failure to
do so will void your warranty.
∗ Use only S&B cleaning and oil
products to service your filter.
Using another company’s oil and
cleaner products may void your
warranty.
[phone] Phone • [phone] Fax
www.sbfilters.com
INSTALLATION INSTRUCTIONS (continued)
13. Install the S&B air box with the
8mm bolts and washers.
19. Connect both CCV lines to the
intake tube.
14. Install the 1/2” hoses and hose
barbs to the OE CCV lines.
20. Reconnect the MAF sensor elec-
trical connection.
16. Install the MAF sensor assembly
onto the intake tube. Fasten the plate to
the tube using the supplied screws.
CHECK THE FLOW DIRECTION
21. Remove the protective film from the
clear lid then attach it to the air box.
17. Install the intake tube and loosely
secure the hose clamps.
18. Install the S&B air filter into the air
box and secure the hose clamp, secure
the hose clamps at the throttle body.
22. Install the engine dust cover and re-
connect the negative battery terminal.
Smog Certification Note:
The California Air Resource Board
(CARB) requires that an E.O. identifi-
cation label be applied to the vehicle in
order to pass a smog check inspection
when installing a High Performance
Intake Kit.
You must place the E.O. label pro-
vided on or near the intake kit after
installation so that the smog technician
can easily verify the O.E. number dur-
ing the smog certification process.
15. Install the plate and gasket onto the
MAF sensor. Fasten the sensor onto
the plate using the supplied screws.
23. Check your installation and make
sure the kit is properly positioned and all
fasteners are secure. Apply the C.A.R.B.
sticker in plain site under the hood.
Your installation is now complete.