Manual

15461 Slover Ave., Fontana, CA 92337 - Phone: [phone] - Fax: [phone] - www.sbfilters.com
INSTALLATION INSTRUCTIONS (continued)
P/N: AS-1009
SEE EXPLODED VIEW ON PAGE 5
3
11. From outside the wheel liner, remove the
screw attaching the plastic faring to the
chrome bumper. Place the Fender liner
bracket assembly behind the fender liner and
attach using the OE screw.
10. Attach the OE clip nut to the Fender
liner bracket (J) as shown.
Air Filter Wrap
Use with Oiled or Dry Filters
Order online today at www.sbfilters.com or
through your local S&B distributor.
Part #: WF-1023
Ride Height
Once the Scoop has been installed, make sure there is plenty space between your tire and the scoop before driving.
The scoop system may not work with aftermarket wheels and tires.
Water Ingestion Disclaimer:
This product is intended for general highway use only! Under normal driving conditions water ingestion is usually not an
issue; however, if the product becomes submerged from rain splashes or mud puddles due to harsh rains or flooding the
engine may ingest water which could cause severe engine damage. Do NOT use this product when crossing any body of
water including but not limited to large puddles, streams, rivers or lakes.
If your engine ingests water, this could cause severe engine damage by hydro-lock or other conditions. Care should be
taken to avoid these driving conditions. ENGINE DAMAGE CAUSED BY THE INGESTION OF WATER INTO THE
ENGINE IS THE DRIVER’S RESPONSIBILITY AND IS NOT COVERED BY S&B FILTERS!
9. Remove the OE clip nut from the wheel
liner support plate using a flat blade screw
driver.
Testing and Maintenance
•
Engage parking brake and start your engine.
Listen for abnormal noises. If an air leak is
detected, re-inspect hoses and connections as
they may need to be repositioned and tightened.
•
S&B FILTERS recommends that you keep
your OE intake system in the event it is
required in the future.
•
In order to maintain your warranty, all connections
and components must be checked periodically for
alignment and for proper tension on all
connections. Failure to do so may void your
warranty.
•
Use only S&B FILTERS cleaning and oil products
to service your filter. Using any other brand oil
and or cleaners on your S&B air filter will void
your warranty.
15. Reconnect the negative battery
terminals. Inspect the installation, be sure the
kit is properly positioned and all fasteners are
secure.
12. Secure the fender liner to the bracket
assembly using the screw removed in Step
#4.
13. Check to make sure the Scoop
assembly does not interfere with the wheel or
wheel well liner. Turn the wheel in both
directions while trying to simulate full
suspension travel.
14. Reinstall the S&B cold air intake kit.
Mount the front of the air box using the
Washer (K) under the tab and secure using
the 3/8-16x2.0” Hex Screw (L). Reconnect
MAF sensor and tighten all clamps.