Operating instructions

F
C
I
Step 3
Step 3: Insert Vertical Tubes into Angle Adjusters.
Set Vertical Tube (F) into Angle Adjuster (C). Make certain that top
portion of Vertical Tube (F) rests FLAT on inner portion of Angle Adjuster
(C) as outlined in above diagram. Screw holes should match up.
Insert 2" Pan Head Screw (I) as outlined in above diagram.
Repeat process for other Vertical Tube.
Lawn Mower Handlebar
C
F
A
B
Step 4
Step 4: Attach Angle Adjuster
Assembly to Handlebar
Clamp Assembly.
Align, attach and PARTIALLY
tighten Angle Adjuster assembly
to Handlebar Clamp assembly as
outlined in above diagram.
Repeat process on other handlebar.
User Tip! Do not fully tighten at
this point. Angle adjustments will be made in later steps. Double check
that Valco Holes, on Vertical Tubes (F), are facing outward and that the
Lawn Stryper
TM
logo, on Angle Adjuster assembly, is facing outward.
8
9
Valco Holes