Operating instructions

Lawn Mower

Handlebars

Valco

Holes

Valco

Holes

Valco Pins

Step 5

Step 5: Attach Hitch Tube and

Corner Tubes to Vertical

Mount System.

Attach Hitch Tube (D) to Corner

Tubes (E) by pressing down on

Valco Pins and locking into place as

outlined in diagram above. Set width

of U-bar assembly (D&E assembled)

to coincide with the width of Vertical

Bar assembly.

Attach U-bar (D&E assembled) to

Vertical Tubes (F) by simply pressing

down on Valco Pins and locking into

place. Make certain Hitch is centered

to lawn mower.

User Tip! When setting width of U-bar assembly, make certain that

Valco Pins are consistent on each side. For example, if Valco Pin is

coming through on hole 2 on left-hand side then Valco Pin should be set

for hole 2 on right-hand side. Doing so will ensure hitch is centered with

lawn mower.

Step 6

Step 6: Setting Angle and Height.

Swing assembly AS CLOSE to mower as possible without hitting

mower or impeding the mower bagging system*. Make certain left

Clamp and right Clamp angles are the same. Once proper angle

is achieved, FULLY TIGHTEN ALL SCREWS (6 total) with

Phillips screwdriver.

Set height of assembly, via Valco Pins, to NO LESS than 3 inches off

the ground. Make certain that heights are the same on left-hand side

and right-hand side.

Place protective vinyl caps (included) on threads of 2" Phillips Pan

Head Head Screws (I). Vinyl cap placement is ONLY necessary when

clamp system is attached to 7/8" handlebars. Vinyl cap placement

protects screw threads from brushing up against bagging system*.

*Bagging system not supplied with all mowers.

IMPORTANT: Assembly must not be hitting the ground – a minimum

of 3 inches of clearance is needed for proper performance. Set height

adjustment to accommodate.