Operating instructions

G
D
Step 7
Step 7: - Attach Roller Assembly to Hitch Tube.
Attach sand filled Roller Assembly (G) onto Hitch Tube (D) by vertically
sliding onto hitch as outlined in above diagram.
User Tip! When you don’t want the patterning effect, or perimeter
cut is necessary, or when there are obstructions such as fence
line, retaining wall, or other objects, remove Roller Assembly (with
mower turned off) while keeping tubing and clamp system intact
(see helpful tips on page 16).
12 13
Finished Lawn Stryper
TM
Double Check:
• Make certain stride does not impede with the roller assembly.
• Make certain Lawn Stryper
TM
attachment is adjusted to the correct
height, width and angle.
• Make certain all clamps, tubes and screws are secure.
Additional width, height and angle adjustments may need to be made based
upon personal preference. Use previous guidelines for reference if adjustments
need to be made.
CAUTION: Do not assemble, disassemble, attach, inspect, or
adjust the Lawn Stryper
TM
attachment while the mower is running.
SHUT
OFF THE MOWER before performing any of these actions.
CAUTION: Do not assemble, disassemble, attach, inspect, or
adjust the Lawn Stryper
TM
attachment while the mower is running.
SHUT
OFF THE MOWER before performing any of these actions.