Product Manual A

PARTS LIST

A: Top Pole Section (20” Straight Pole) (1) B: Pole Sections (53 1/2” Swedged Pole) (3)

C: Pulley Topper, Pulley Wheel, Nut, Bolt (1) D. Rope Cleat (1)

E: 22 Ft. Nylon Rope (1) F: Rain Guard with 2 Snaps(1)

WARNING!

DO NOT ERECT POLE NEAR ELECTRICAL WIRES!

RP19

012009v8

1. Determine site for pole, 30 to 40 feet from trees and other obstructions. Dig

a 12-inch diameter hole, 20-inches deep. Pour 2 inches of concrete into the

hole and allow to dry overnight. After concrete sets, insert a SWEDGED Pole

Section (B) into center of the hole - the SWEDGED

PART OF POLE UP.

Plumb pole section. Fill hole OUTSIDE of the POLE with concrete or

QuikCrete - following product’s directions. Allow concrete to harden

completely.

2. After concrete has completely hardened, add a swedged pole section (B) onto the top

of the standing pole section.

3. IF USING AN S&K PRODUCT that slides over a round or square pole, slide the

product over the two standing pole sections at this time.

4. Assemble the pulley by pushing the screw through the

topper and pulley wheel, and screw into the accompanying

nut until tight.

SITE PREPARATION

IF ANY ITEMS ARE

DISCOVERED MISSING,

CALL

1-800-764-8688

DO NOT RETURN TO STORE.

1. 9 ” R OUND POLE

INSTRUCTIONS

Swedge

at Top!

PAGE 1
RP19 INSTRUCTIONS 1.9” ROUND POLE 012009v8 WARNING! DO NOT ERECT POLE NEAR ELECTRICAL WIRES! A IF ANY ITEMS ARE DISCOVERED MISSING, CALL 1-800-764-8688 DO NOT RETURN TO STORE. B C D E PARTS LIST A: Top Pole Section (20” Straight Pole) (1) C: Pulley Topper, Pulley Wheel, Nut, Bolt (1) E: 22 Ft. Nylon Rope (1) F B: Pole Sections (53 1/2” Swedged Pole) (3) D. Rope Cleat (1) F: Rain Guard with 2 Snaps(1) SITE PREPARATION 1. Determine site for pole, 30 to 40 feet from trees and other obstructions.
PAGE 2
5.If adding an S&K American Barn, Great 8, or Heavenly Haven Purple Martin Houses/Barns to the pole, attach the Rain Guard to the pulley topper with two snap buttons - in the placement shown. Ensure the pole’s rope slides through and lines up with the Guard’s rope opening. 6. On the ground, push the two remaining pole sections together, and place the Topper Pulley (C) over the unswedged section of the last two pole sections. The Topper Pulley (C) will snap into place on the Top Pole Section (A). 7.