Operation Instructions

ManualsBrandsS.Q.M ManualsElectronicsWall-mounted remote control

INSTRUCTIONS FOR OPERATION

SETING THE OPERATING CONTROLS

1. This device which one of black lines series with AC 120V power supply. Now, we take 60Hz

power supply to afford power supply of transmitter when it trough rectify. So, there is no

troubles with change batteries forever.

2. Store the controller away from excess heat or humidity .

3. Transmission controls speed and light of fan through 26 bit encoding connection signal, 10

buttons and 10sets switch .Integrated circuits through theRF transmission,Carrier is composed of

quartzoscillator.

4. Operation buttons on the panel of transmitter .

6key – For fan speed 6

5key – For fan speed 5

4 key – For fan speed 4

3key – For fan speed 3

2key – For fan speed 2

1key – For fan speed 1

key – For fan speed off .

key – Fan reverse .

key – For light brightness and ON/OFF control .

5. Start the fan :

Press the selected speed button to run the fan at the desired .

By press the speed up-down button to select the needed speed, and though the LED light to see the

fan speed.

6. Turn off the fan :

Press the OFF button .

7. Light control :

Turn the light on or off by only touching the LIGHT CONTROL button .

Keep pressing the button in excess of 0.7 second it becomes a dimmer ,

the light varies cyclically in 0.8 second .

One of the important feature of this control is AUTO-RESUME . After power

on , it allows the light return to where it was off .

8. Power switch

Turn off the power for Fan and Light

GENERAL INFORMATION :

This REMOTE controller is designed to separately control your

ceiling fan speed and light brightness .

Summary of content (4 pages)

PAGE 1
INSTRUCTIONS FOR OPERATION SETING THE OPERATING CONTROLS 1. This device which one of black lines series with AC 120V power supply. Now, we take 60Hz power supply to afford power supply of transmitter when it trough rectify. So, there is no troubles with change batteries forever. 2. Store the controller away from excess heat or humidity . 3. Transmission controls speed and light of fan through 26 bit encoding connection signal, 10 buttons and 10sets switch .
PAGE 2
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER A. Setting the code on your new transmitter . 1. Slide code switches to your choice of UP and DOWN position . Factory setting is all UP . Do not use this setting . Use ball point pen or small screwdriver . Slide firmly up or down . B. Setting the code on your new Receiver unit . 1. Slide code switches to the same positions as set on your transmitter . They must be set to same positions to work . 2.
PAGE 3
FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 4
IC Caution: This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.