Service manual

3

See Picture 3.

See Picture 3.
See Picture 4.

  

 

See Picture 5, below.
  




NOTE: The gasket must be positioned evenly around the S&S® Super E or G
carburetor bore. If the gasket is too low then it may not seal at the bottom
of the bore and poor performance may result. See Picture 6, below .
 


    
 See Picture 7.
NOTE: Make certain the intake manifold is fastened tightly before
continuing.
 
          
       





See Picture 8.
CAUTION
If the shims used are too thick or not thick enough then damage
to the intake manifold and the carburetor or throttle body may
result. This can potentially cause leaks in the system.
        





See Picture 9.
Picture 6
Picture 5
Picture 7
Picture 8
Picture 9