Service manual


      
        
       
       

2- Install Gear Drive Cams
NOTE: Do not reuse cam bearings. If S&S Camshaft Installation Kit 106-
5896 is not being used, new bearings should be obtained from another
source and installed with new camshafts. The S&S Gear Drive Cams
require that ball bearings be used for both front and rear camshaft outer
bearings.
          
       
        See Pictures 5
& 6 above.       
         
         
        


  

 
    

        
        

 
        
       
       See
Picture 8 below.
NOTE: Check clearance between bearing retainer and woodru keys
securing inner gears to cams. Remove material from retainer, to provide
.030" clearance between key and retainer. See Picture 9 below.
 
         

           

Picture 7, below.
  
         
          

NOTE: Do not reuse retaining ring. If S&S Camshaft Installation Kit 106-
5896 is not being used, a new retaining ring be obtained from another
source and installed with new camshaft.
          
Picture 8 Picture 9
If additional clearance is required, remove
material from areas indicated to provide
.030" clearance between key and retainer .
Picture 5 Picture 6
Picture 7