User's Manual

16
10b. Install Non-rechargeable
battery. Remove the BU. Remove
the battery holder from the BU.
10c. Put the battery in the battery
holder. Verify that "Tampering kill"
is heard from the speaker.
11. Use the CGUN and shoot a
RESET Command. Message
"RESET WALL TYPE NO" is heard
from the speaker. The speaker
confirm that wall type level in primary
room is set to default value given by
the SID. To start the configuration of
the RADs, shoot an ACCESS
Command with the CGUN.
12. The SES is generating a
"primary room" audio cue. Put one
RAD installed in primary room in
front of the laser detectors. Repeat
the procedure when SES is
generating a "secondary room"
audio cue. The SES will confirm
each Room ID.
13. Message "System OK" is heard when the system is ready.