Operation Manual

259Car care
Malfunctions
The above message is shown on the SID if:
• a wheel without pressure sensor has
been fitted (e.g. spare wheel)
• one or more pressure sensors are broken
or missing
• a fault has arisen in the receiver
• a system error has arisen.
Removing a tire
Remove the tire with a tire machine. It is
important to follow the instructions for the
tire machine as well.
• Do not fit the tire tool in an area ±10° from
the valve.
• Start removing opposite the valve.
• Remove the rear side first.
Fitting a tire
Fit the tire with a tire machine. It is important
to follow the instructions for the tire machine
as well.
• Start to fit about 20° after the valve.
• Finish fitting before an area 20° from the
valve.
• Do not inflate the tire to a pressure higher
than 102 psi (700 kPa).
Tire pressure system
failure. Contact service.
93_US_M08.book Page 259 Friday, May 11, 2007 11:37 AM