User's Manual

SL-TVWS-1001-User Manual and Installation Guide
Copyright Saankhya Labs Private Ltd, Bangalore
4) If there are no networks found the CPE will reboot on its own
5) After moving to operational mode if CPE loses the network it will perform scan for the last
registered band and then full range of frequencies automatically.
9.4 Register with selected Network
On successful registration, the CPE screen should display the following information as indicated in Figure
23
- The frequency at which CPE is registered
- Incrementing values of frame count
- Base station MAC address and IP address (IP address always shown as 0.0.0.0 in current release)
Figure 23 CPE successful registration at CPE GUI
Similarly, on the Base station side, you would see logs corresponding to CPE registration as indicated in
Figure 23.
9) White Space Database Usage
In geographies which have regulations on usage of TV white space frequencies, the sharing of the
spectrum is controlled by White Space Data Base (WSDB). Saankhya Labs sells devices with the WSDB
feature enabled in these geographies and the configuration of the service providers described in Section
7) and 9)
It is advised that the source of location information be set to GPS as against manual while using this
feature, although it is not mandatory. The GPS device used provides 95% location accuracy when latched.