Use and Care Guide

START UP
• Temperature control set at #4 position gives the cooler an approximate temperature
of 35°F. Allow unit to function several hours, completely cooling cabinet before
Plug in the cooler and the compressor is ready to operate.
changing the control setting
• Excessive tampering with the control could lead to service difficulties. Should it
ever become necessary to replace the temperature control it should be ordered
from your dealer or recommended service agent.
• Good air flow in your cooler is critical. Be careful to load product so that it neither
presses against the back wall nor comes within four (4) inches of the evaporator
housing. Refrigerated air off the coil must circulate down the back wall.
LIGHT SWITCH LOCATION:
The switch is located on the front of the evaporator housing toward the right of the
cabinet. Open the front door
NOTE:
If the unit is disconnected or shut off, wait five (5) minutes before re-starting unit.
RECOMMENDATION
Before loading product the unit should be run for 2 to 3 days. This allows confirmation
that the electrical wiring and installation are correct and no shipping damage has
occurred. Remember that the factory warranty does not cover product loss.
REPLACEMENT PARTS
We maintains a record of the cabinet model number and serial number
for your cooler. If at any time during the life of your cooler a replacement part is
needed, call the factory office with the model number and serial number of your unit
to place an order for the part.