Specifications

ManualsBrandsSABINE ManualsMusical equipmentSWM6000

Sabine Smart Spectrum

Wireless

LIT-SWM6-7000-OG-EN-090317.indd - rr

4.2.4.2. Charging Your Batteries

Equipment Connections. Each SW65- & 75-T or SW-H Series trans-

mitter comes equipped with an SWC-POWR Tireless Wireless™ plug-in

charger (see Fig. 4l). In addition, each SW-H comes with its own battery-

charging mic clip (SWC70-CL). The SWC-POWR charger can be plugged

directly into either the transmitter or into the clip. A Sabine rechargeable

battery (SWBC1) will charge whenever the mic clip is connected to the

Sabine SWC-POWR charger and the handheld is properly placed within

the mic clip.

Charging Indicators. Much like your cell phone, the transmitters will let

you know the charging status of the battery. When the battery is charg-

ing, the battery meter will ﬂash to indicate the relative level of the charge

— one, two, three or four elements will ﬂash (see Fig. 4i).

Once the battery is fully charged, all four elements in the battery meter

will ﬂash. This indicates that the charging circuit is no longer on (see Fig.

4j).

NOTE: The right-side indicator segment will ﬂash for several minutes

when charging is ﬁrst attempted (see Fig. 4h). The lower the battery

level, the longer this initial “testing/not charging” ﬂashing sequence will

continue. During this time, the Tireless Wireless battery circuit is evaluat-

ing the suitability and charge status of the battery in place. When it has

completed its evaluation, it will either commence the progressive ﬂashing

depicted in ﬁgure 4i (CHARGING), or continue to ﬂash (TESTING/NOT

CHARGING). All segments ﬂashing in unison signiﬁes that the battery is

fully charged (see Fig. 4j).

These same indications will also be displayed on the receiver LCD, and

on the Remote Control Software screen.

NOTE: The Tireless Wireless battery charger will only charge NiMH

rechargeable batteries. If you place any other kind of battery in the

transmitter, and then attempt to charge it by connecting the charger, the

Tireless Wireless circuit will detect the type of battery and will not begin

charging. Again, the battery indicator on the transmitter will ﬂash the

right-side element indicating testing/no charging (see Fig. 4h).

Battery Warnings. When the transmitter battery voltage drops below a

critical threshold, the battery icon (which normally displays the voltage

level) will begin to ﬂash. This will occur on the transmitter and receiver

and is an indication that you need to replace the battery, or charge it by

placing the handheld mic in the charger clip. NOTE: Microphone will still

transmit audio when placed in clip. Alternatively, you can connect the

charger directly to the transmitter using the built-in charger jack located on

the side of the beltpack transmitter and near the antenna on the handheld

transmitter (see Fig. 4l). If the battery is not changed or recharged, the

transmitter will eventually turn off (see Fig. 4k).

Transmitter Operation

Fig. 4l: SWC-POWR plug-in charger for SW70 Series Transmitters & SWC70CL Mic Clip

Fig. 4h: TESTING/NOT

CHARGING

Right-side battery indicator

segment will ﬂash to indicate

that the battery is being

tested. This occurs prior

to charging a NiMH battery and whenever a

non-rechargeable battery is placed on charge.

Charging is not occuring when indicator lights

in this fashion.

Fig. 4j: FULL CHARGE

Battery indicator segments

will ﬂash in unison to indi-

cate that the battery is fully

charged.

NOTE: Battery can be left

connected to the charger and will receive peri-

odic maintenance charging.

Fig. 4i: CHARGING

Battery indicator segments

will ﬂash progressively start-

ing from the relative charge

state of the battery. This

example depicts a fully dis-

charged battery being charged. As the charge

progresses, left-side segments will remain vis-

ible as right side segments continue to ﬂash,

until all segments are visible. At that point, all

segments will ﬂash on and off in unison (see

Fig. 4j).

Fig. 4k: Battery CHARGE LEVEL displays

NOTE: When the battery has reached a

speciﬁc discharge level, the transmitter

will automatically turn

off, and the transmit-

ter LCD will display the

message at right.

Very Low (Flashing)

Very Used

Partially Used

Fully Charged

SW65/75T

SW70H1

SWC70CL

(Mic Clip for SW70H1)