User Manual- FSB 8

- 10 -
FSB 8Manual
By locking the 1/4” screw in the thread of the camera, the
desired position will be fixed.
Please pay attention to the arrow on the camera plate,
which is indicating the direction of the camera lens.
If your camera was delivered with a tripod adapter plate
you may need 1/4" and 3/8" screws to mount your came-
ra. Remove the guided sled by unlocking the 1/4” screw.
Use the 1/4” and 3/8” screw (parking position below the
top plate) to mount your camera on the camera plate.
B. Touch & Go
The fluid head FSB 8 T is delivered with the Touch & Go
plate S (code No.0364). It comes with a pin, 1/4” screw
and 3/8” screw, means the camera plate is ready to use it
either with a pin - 1/4” screw connection or a 1/4” screw -
3/8” screw connection. Just unscrew the not needed
screw from the camera plate. Spare camera screws are
stored in the balance plate.
If your camera remains front- or back heavy after going
through the necessary centring procedure (paragraph 3.4)
you may solve this by using the C.O.G plate DV
(Code No. 1465). This plate offers you two removed posi-
tions (by about 44 and 72 mm resp.) to receive the
camera.
The C.O.G plate DV can be mounted removed to either
the front or the back. It comes with 1/4” screw and pin.
5.2 Pan bars
The fluid head FSB 8 comes with a single pan bar DV 75.