User's Manual
13
1st Time Installation
4. To set the connector tension, raise the tripod so the head is at
eye level.
5. Lift the SpeedLevel Lever on the head and hold with “S triangle”
aligned to the mark on the body.
45°
60°
CAUTION! Push the SpeedLevel Lever fully closed against the
head body before use.
The tension is correct when the SpeedLevel Lever is released and
from the body of the head as shown in the diagram below.
loose, repeat steps 5 and 6.
CAUTION! Try and lift the head to ensure the head is fully
secured to the tripod.
Approximately 45° to 60° from the body
6.
turning clockwise to remove all clearance.