User's Manual

QUICKSTARTGUIDE
Connect CHARGEit Dock to power via the USB ‐C cable attached (adapter not included). It is
recommended to use QC2.0or QC3.0 adapters.
Use CHARGEit Dock
1 You can load trSdlos by placing your unit p3 X if your unit supports trSdlos loading
2. You can charge the charging cable by attaching the charging cable from your device to the USB
entrance in CHARGEit
3. You can charge a unit via a tray charging eye unit via cable at the same time
4. If you place the device on CHARGEit However, the blue LED lamp will flash if the device is not
capable of charging without the console
If you experience problems loading your device correctly, make sure you use a QC2.0 or QC3.0
adapter.
User
Warning: Read the package leaflet before use. Get manual online on the following link: sackit.dk
/support. Here you can download the user manual and save it for later use. In the User Manual
you will find instructions and important safety information
Federal Communications Commission (FCC) Statement
This device complies with part 1 5 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
●Reorient or relocate the receiving antenna.
●Increase the separation between the equipment and receiver.
●Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
●Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.