Installation Instructions

① Touch the switch, the power indicator light on and display
the remaining power capacity, wireless charging indicator light will
turn off after blue light and green light flash alternately.
② When the mobile power is charged, the white LED light is
prompted to charge in the form of a running horse lamp, which is
extinguished after 30 S. Mobile power discharge, the current power
LED always bright ,30 S after extinguishing.
*The wireless charging will shut down automatically if mobile phone
leave mobile power bank for 30 seconds, and please touch start again
if need charging.Wireless charging can be realized through the battery-
powered coil if USB-C port without power connection .
① Connect the power adapter to socket.
② Connect adapter to the USB2.0 interface, the other micro USB
to the power bank.
*When linked to power supply, the power bank will charge mobile
phone firstly and then charge the power bank when the phone fully
charged or move away.
Battery: Polymer Li-ion Battery Battery capacity: 6000mA
Input voltage: DC5V/2A DC9V/1.67A
Output voltage: 5W/7.5W/10W
USB-A output voltage: 5V/2.1A
Dimensions: 140*80*24mm
对手机进行无线充电
通过USB对设备进行充电
① 轻按开关，电源指示灯点亮并显示剩余电量，无线充电指示
灯蓝绿交替闪烁后熄灭。
② 当移动电源充电时，白色LED 灯以跑马灯形式提示充电，30S后
熄灭。移动电源放电时，当前电量 LED 常亮，30S后熄灭。
*当手机离开移动电源30秒，无线充电自动关闭，如再充电需要需重新
触摸启动。在USB-C 口没有接电的情况下可通过电池供电线圈实现无
线充电的功能。
② USB电源线一端连接适配器，一端连接移动电源。
*当移动电源进行充电时，放入手机进行无线充电，程序将停止对
移动电源充电，优先对手机进行无线充电。
无线充电移动电源
电池类型：聚合物锂电池 电池容量：6000mA
输入电压：DC5V/2A DC9V/1.67A
输出电压：5W/7.5W/10W
USB-A输出：5V/2.1A
规格尺寸：140*80*24mm
内含：无线充电移动电源、150cm电源线、产品说明书
*不含电源适配器，如需要请另外购买或使用手机原装适配器。
Charge your mobile phone wirelessly
Charging device with micro USB
*AC adapter is excluded, please buy separately or use
the mobile phone original adapter if need.
Portable Wireless
Charging Power Bank
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party
responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This
equipment should be installed and operated with minimum
distance between 20cm the radiator your body: Use only the
supplied antenna.
FCC ID:2AO5W-CHARGEITS
Warning: Changes or modifications to this unit not expressly
approved by the part responsible for compliance could void the
user’s authority to operate the equipment.