Coffeemaker - Coffee System User Manual

6
INSTALLATION /
PRIMING
Fill the coffee bean container
with coffee beans.
Fill the tank with fresh
water.
Move the ON/OFF switch
to “I” to turn on the
machine.
Insert the plug into a sui-
table outlet.
See rating plate
Place a container under
the steam wand.
Press the hot water
button.
Turn the knob countercloc-
kwise to start priming the
machine.
Wait until a steady stream
of water flows out from the
nozzle.
The machine is ready for
use.
Press the water button
again.
Turn the knob clockwise to
stop the priming process.
The machine is warming
up; lights are flashing.
Note: Prime the machine during initial set up, if the
machine has not been used for several days, after
refilling the water tank, or any time the priming in
-
dicator light flashes.
Remove the container.
The messages displayed by the machine during operation are shown on page 14.