mod. SAECO D.A. 7P ISTRUZIONI 1) kclj
1 - General information ................................... 2 - Technical features ....................................... 3 - Safety precautions and operating procedure . 4 - Controls ..................................................... 5 - Installation ................................................. 6 - Operation .................................................. 5 5 5 6 6 8 7 - Supply ....................................................... 8 - Cleaning and maintenance ..........................
6 7 8 9 10 11 12 13 26 14 15 16 17 18 19 2 1 3 4 20 5 33 26 21 22 32 31 30 23 24 29 28 25 27
English Legend 1 2 3 4 5 6 7 8 9 10 11 Soluble product bins Water tank Coffee hopper cover Coffee bean hopper Cup dispenser tubes Sensor switch “Orange key” Reset switch Connection for 7P programmer Rinse switch Selection buttons 12 13 14 15 16 17 18 19 20 21 22 Green LEDS Red LEDS Green LED “Ready for use” Red LED “Water empty” Coin display Coin slot Coin return button Stirrer dispenser button Stirrer dispenser slot Shutoff slide Stirrer magazine cover 23 24 25 26 27 28 29 30 31 32 33 Sugar dispenser
English VENDING MACHINE FOR HOT BEVERAGES D.A. 7P 1 - GENERAL INFORMATION 1.1 Manual purpose • Purpose of this manual is informing user of all functions of the vending machine, simplifing its use and achieving the highest performances. 2 - TECHNICAL FEATURES 2.1 Machine description • The DA 7P is an automatic dispenser which rapidly serves a freshly ground cup of espresso and hot beverages made from soluble products. In all the user has a selection of 7 different beverages.
English 4 - CONTROLS • Main swicth: placed on the machine rear side, below on the right. • Selection panel: consisting of 7 selection buttons (11) which correspond to the same number of beverages marked as A-B-C-D-E-F-G. • Display (16): displays the inserted coln value. • Green LEDS (12) next to the selection buttons: they will illuminate when beverages are available (once the user has inserted coins for a corresponding or higher amount than the one established). N.B.
English 5.4 Set up • Fill the water tank (2) (except for those machines directly connected to the waterline), the coffee bean hopper (4) and the soluble product bin (1), paying attention not to fill the latter over 2/3 of their max. capacity and to set them in the right position (Pos.1 Tea or other drinks, Pos.2 Chocolate, Pos.3 Milk) (Fig.B).
English 6 - OPERATION 6.1 Beverage Dispensing • Select a beverage among those available and check the corresponding amount. • Insert coins into the slot (17) until the required amount is displayed on the coin display (16). N.B. If you insert a higher amount, the machine will neither return change nor retain the credit. • Extract a cup from the holder and place it at the dispensing point (25). • Press the button corresponding to the desired beverage.
English • Attention: The cup tubes hold only cups with a max. diameter of 70 mm. and a max. length of 90 mm. • Sugar dispenser • Put the packets into the special dispenser, located behind the front door panel. • Attention: For hygienic reasons, we recommend to use sugar packets only (no sugar lumps). 7.2 Counter reset • The machine is fitted with different electronic counters.
English Fig. H Fig. L Fig. M Fig. N 10 clockwise and remove it. Wipe the mixing blade with sponge and lukewarm water, without pressing too hard as not to compromise the positioning of the seal gasket. • Wash with warm water all parts and reinstall them, repeating backwards the above-mentioned operations. Pay special attention to re-install correctly the nozzle with silicone tube.
English 9 - AUXILIARY FUNCTIONS : • The machine is provided with some special controls which allow following operations: • Front panel LED test • Descaling boiler • Calibration of soluble product specific weight • Access to the special controls: • Switch the machine off, open the front door panel and override the sensor switch (7) by inserting the “orange key “(8). Switch the machine on by the main switch pressing simultaneously the reset button.
English 10 - MB7P CABINET - INSTALLATION AND USE 40 41 Fig. P Fig. R Fig. S 43 42 Fig. T 12 • The M.B.7P cabinet allows a greater autonomy and increases the supply interval. • Remove the cabinet from its packing as well as all parts contained in the inside of the cabinet. • Position the drain adapter (40) on the cabinet top and connect it to the drain hose (41)(Fig.P). • Set the free end into the drain tank.
English 11 - NRI G13 COIN VALIDATOR PROGRAMMING 50 54 • The vending machine is normally equipped with NRI G13 coin validator which can recognize up to 6 different coins or money pieces. • Values of the programmed coins are given in table (50), positioned next to the coin validator(TK 2007 and TK 2008 point out 24 mm. and 28 mm. coins).
DEUTSCHLAND: SAECO Handelsgesellschaft mbH Hermann-Laur-Str. 4 D-78253 Eigeltingen Tel.: 07774/50510 Fax: 07774/50597 ITALIA SAECO S.p.A. Via Torretta I - 40041 GAGGIO MONTANO (Bologna) Tel.: 0534-30009 Fax: 0534-31125 ÖSTERREICH: SAECO Kaffeemaschinen Bahnhofstr. 9 A-6922 Wolfurt Tel.: 05574/30550 Tel.: 05574/6777 - NEU ab 19.11.1993 Fax: 05574/30360 Fax: 05574/6777-77 - NEU ab 19.11.1993 ESPAÑA: SAECO Iberica S.A. San Fernando 34 08940 Cornella Pol. Ind. Almeda (Barcelona) Tel.