Service manual

INCANTO S-CLASS 3. OPERATION
Saeco International Group REV.1 FEB.2005 Page 7/21
Troubleshooting
Fault Cause
Remedy
Turn on main switch. The machine does not switch
on.
The machine is not connected to the
mains power supply.
Check plug and connection.
The cups are cold. Pre-heat cups. The coffee is not hot enough.
A low temperature has been set. Set the machine to a higher
temperature.
Only hot water is dispensed
when powder coffee is
selected.
No powder coffee has been filled. Fill powder coffee and start
once again.
No hot water or steam. The nozzle is obstructed. Clean nozzle out with
needle.
Dial is closed!
The machine is switched
off!
Machine heating takes a long
time.
The machine is heavily calcified. Descale the machine.
The brewing unit cannot be
removed.
The brewing unit has stopped in an
incorrect position.
Close doors and switch on
the machine.
The machine performs a re-
positioning.
Grind too fine. Set grind to higher level.
Turn knob in clockwise
direction.
Coffee dispensing insufficient
or absent.
SBS is set to the right side. Turn SBS knob to the left.
Cannot dispense
The descaling indicator flashes
(machine not locked)
- Descale
Water LED lights up
- Fill with fresh water
Water LED flashes
- De-aerate machine
Coffee beans/grinds container LED
lights up
- Fill with coffee beans
Coffee beans/grinds container LED
flashes
- Empty grinds container
(for min. 6 sec. / machine must be turned on)
Warning LED lights up
- Correctly install brewing unit, drip tray and grinds
container, and close door.
Warning LED flashes
- Grinder obstructed.
- Gears obstructed
- Contact an authorised service centre.
Filter indicator flashes (machine not
locked)
- Replace Aqua Prima filter / turn indicator off
(press the hot water button for about 6 sec. until
filter indicator light flashes).