Manualshelf

Service manual

ManualsBrandsSaeco ManualsCoffee MakerEasy
61626364656667686970
INCANTO S-CLASS 5. SERVICE PROGRAMME
Saeco International Group REV.1 FEB.2005 Page 11/18
Function/Standard Setting range Increment Comments
Water flow since
descaling indicator
(ml) Number
0 - 999999999 +/- 1 Water flow since the need for
descaling was signalled.
(reset via descaling procedure)
HOT WATER
FLOW (l/h) 14
6 - 26 1/h +/- 2 1/h The pump delivery rate for hot
water can be expressed in litres per
hour.
HOT WATER
PUMP ADJUST. 63000
58,000 - 65,500 +/- 1 The pump delivery rate is adjusted in
relation to the HOT WATER FLOW
setting by means of a phase
controlled modulator. Pump
tolerances can thus also be adjusted.
An equivalent value is saved under
HOT WATER PUMP
ADJUSTMENT.
WATER RESERVE
COUNTER
NUMBER
When the water tank is full, the value
from WATER RESERVE STOP is
applied. The flow meter pulses are
counted from when the reed switch is
switched and deducted from the
value. If a beverage is chosen for
which the saved pulse number is
higher than the remaining pulses, the
message FILL WATER TANK
appears.
WATER RESERVE
STOP 420
Water reserve from when the read
switch is switched to pulses.
CLEANING CYCLE
Counter Number
Counter the cleaning cycles
performed.
CLEANING CYCLE
Status NUMBER
Status of cleaning programme
0/1 (1= Programme activated)
DESCALING
Counter Number
Counter the descaling cycles
performed.
DESCALING
Status NUMBER
Status of descaling programme
0/1 (1= Programme activated)
MACHINE STATUS
36
0 - 255
Programme code
--DATE OF MANUF---
TAG
---------------------
---------------------
--
--DATE OF MANUF---
MONTH
---------------------
---------------------
--
--DATE OF MANUF---
YEAR
---------------------
---------------------
--
This date indicates when the machine
was manufactured. This date cannot
be changed.
--SERVICE DATE--
DAY
0 - 31 +/- 1
--SERVICE DATE--
MONTH
0 - 12 +/- 1
--SERVICE DATE--
YEAR
1996 - 2050 +/- 1
The service date indicates the date of
the machine's last service. This date
can be changed and must be updated
at each service.
Exit: Switch the machine off at the main switch.