Operating instructions

42
Help Message Displayed How to Reset the Message
TURN CARAFE
INTO
BREWING POSITION
ESC
Abeveragewithmilkhasbeenselected.Themachinerequiresthecarafehandle
spout to be placed into dispensing position.
Press the button "ESC" to cancel the selection.
TURN CARAFE
INTO
RINSING POSITION
ESC
The carafe rinse function has been selected.
Press the button "ESC" to cancel the selection.
INSERT CARAFE
ESC
Theselectedoperationrequiresthemilkcontainerforbrewing.Insertthecontainer
inthemachineasspeciedinthemanual.
Press the button "ESC" to cancel the selection.
Perform a descaling cycle on the machine.
When this message is displayed, it is still possible to use the machine, but its correct
operation might be compromised.
Damagescausedbyfailuretodescalethemachinearenotcoveredbywarranty.
Themachinerequeststhe"Intenza"waterltertobereplacedwithanewone.
Replacethelterasdescribedonpage7.
The alarm is displayed only if the "Enable Filter" function is set to "ON".
(Seepage28).
Flashingredlight.MachineinStand-by.
TheStand-bysettingscanbechanged.
Press the " " button.
RESTART TO SOLVE
Aneventhasoccurredwhichrequiresthemachinerestart.
Takenoteofthecode(Exx)shownatthebottom.
Switchothemachine,wait30secondsandthenswitchitonagain.Iftheproblem
persists,contacttheservicecentre.
MACHINE WARNINGS