PICOBARISTO HD8924 EN DE ES FR IT NL USER MANUAL BENUTZERHANDBUCH MANUAL DEL USUARIO MODE D’EMPLOI MANUALE UTENTE GEBRUIKSAANWIJZING 4219.460.3607.1 HD8924 SAECO_PICOBARISTO AMF_WE_COVER_A5_FC.
1 2 3 4 ESPRESSO MILK FROTH 14 ESPRESSO LUNGO HOT WATER 13 17 12 18 AROMA STRENGTH CAFFE CREMA MENU / SPECIAL DRINKS 19 5 6 7 8 9 10 11 15 22 21 20 16 23 24 42 25 41 40 39 26 38 27 28 37 29 35 36 30 31 34 32 33
English 5 Contents Machine overview_________________________________________________________________ Introduction ______________________________________________________________________ First installation___________________________________________________________________ AquaClean filter __________________________________________________________________ Activating the AquaClean filter_______________________________________________________ Replacing the AquaClean filter______________________________________
English Machine overview 1 User interface 22 Service door 2 ESPRESSO button 23 'Drip tray full' indicator 3 ESPRESSO LUNGO button 24 Drip tray 4 CAFFÈ CREMA button 25 Drip tray release button 5 Escape button 26 Cord 6 OK button 27 Grind setting knob 7 Standby button 28 Cover of bean hopper 8 Display 29 Bean hopper 9 MENU/SPECIAL DRINKS button 30 Brew group 10 UP button 31 Inside of service door with cleaning instructions 11 DOWN button 32 Coffee exit duct 12
English 7 - This is the QR code. Scan this code to access instruction videos on how to brew the best coffees, how to clean the machine and for a list of frequently asked questions. (www.saeco.com/care) - The separate booklet with important safety information. First installation For first installation, follow the instructions on the separate quick start guide. Note: This machine has been tested with coffee. Although it has been carefully cleaned, there may be some coffee residues left.
English AQUACLEAN FILTER 0/8 ACTIVATE AQUACLEAN FILTER? 2 MIN INSERT FILTER FILL WATER TANK INSERT WATER SPOUT PLACE A CONTAINER UNDER THE WATER SPOUT 2 Press the MENU/SPECIAL DRINKS button, select MENU and press the OK button to confirm. Scroll to select AQUACLEAN FILTER. Press the OK button to confirm. - The display shows the number of AquaClean filters that have been installed previously from 0 to 8 filters. 3 The display asks if you want to activate the filter.
English 9 Replacing the AquaClean filter Note: Replace the AquaClean filter as soon as the capacity has dropped to 0% and the filter icon flashes quickly. Replace the AquaClean filter at least every 3 months, even if the machine has has not yet indicated that replacement is required. AQUACLEAN FILTER 2/8 Tip: We advise you to buy a new filter when the capacity has dropped to 10% and the filter icon starts flashing slowly. This ensures that you can replace the filter when the capacity has dropped to 0%.
English number of red squares value to be set water hardness 1 very soft water 2 soft water 3 hard water 4 very hard water 4 Press the MENU button, select menu and scroll to select water hardness. Select the preferred water hardness setting and press the OK button to confirm. Control panel and display This espresso machine has a self-explaining display for easy use. Read the sections below for a quick explanation of the buttons.
English 11 - Stand-by time: this is the time after which the machine goes into standby mode. - Water hardness: to be able to adjust the machine settings to the water in your region, please measure the water hardness. - To activate the AquaClean filter - To start descaling AROMA STRENGTH button Use the AROMA STRENGTH button to adjust the coffee strength (see 'Adjusting coffee strength') or to brew pre-ground coffee. Brewing coffee Brewing coffee with beans Caution: Only use espresso beans.
English Frothing milk Warning: Danger of scalding! Dispensing may be preceded by small jets of hot water. Use the appropriate protective handle only. Note: Use cold milk (at a temperature of approximately 5°C/41°F) with a protein content of at least 3% to ensure an optimal frothing result. You can use whole milk or semi-skimmed milk. It is also possible to use skimmed milk, soy milk and lactose-free milk. 1 Insert the suction tube into the automatic milk frother.
English 13 Hot water Warning: Danger of scalding. Only grab the steam wand by its protective handle. Dispensing may be preceded by small jets of hot water. 1 Remove the automatic milk frother from the hot water/steam dispensing spout. 2 Place a container under the hot water/steam dispensing spout and press the HOT WATER button. - Hot water dispensing starts automatically. 3 Press the OK button to stop hot water dispensing. Remove the container.
English Beverage lengths Beverage name Standard length Length range Espresso 40 ml 20 - 230 ml Ristretto 30 ml 20 - 230 ml Espresso Lungo 80 ml 20 - 230 ml Caffè Crema 125 ml 20 - 230 ml Espresso Double 60 ml (double grinding) 40 - 230 ml Hot water 300 ml 50 - 450 ml Adjusting volume and taste Adjusting coffee and milk volume You can adjust the volume of the beverage brewed according to your taste and to the size of the cups.
English 1 2 3 4 5 1 2 3 4 15 Very mild Mild Regular Strong Very strong Note: The machine automatically dispenses the correct coffee volume for each coffee strength. 5 Note: You can also use the AROMA STRENGTH button to brew coffee with pre-ground coffee. Note: After adjusting the coffee strength, the display shows the main menu again and saves the chosen aroma strength when you brew a coffee.
English Cleaning table Part description When to clean How to clean Brew group Weekly Remove the brew group and clean it under the tap (see 'Cleaning the brew group under the tap'). Depending on the type of usage Lubricate the brew group (see 'Lubrication'). Monthly Clean the brew group with the coffee oil remover tablets. After every use Perform the quick clean procedure for the milk system (see 'Quick cleaning of the milk frothing system').
English 17 Cleaning the brew group under the tap 1 2 3 4 Switch off the machine and unplug it. Remove the drip tray with the coffee grounds container. Open the service door. Press the PUSH button (1) and pull at the grip of the brew group to remove it from the machine (2). 1 2 5 Rinse the brew group thoroughly with lukewarm water. Clean the upper filter carefully. 6 Let the brew group air-dry. Note: Do not dry the brew group with a cloth to prevent fibers from collecting inside the brew group.
English 1 Before you slide the brew group back into the machine, make sure the two yellow reference signs on the side match. If they do not match, perform the following step: - Make sure the lever is in contact with the base of the brew group. 2 Make sure that the yellow locking hook of the brew group is in the correct position. - To position the hook correctly, push it upwards until it is in uppermost position. - The hook is not positioned correctly if it is still in bottommost position.
English 19 3 Apply a thin layer of grease around the shaft in the bottom of the brew group. 4 Apply a thin layer of grease to the rails on both sides (see figure). 5 Reinsert the brew group (see 'Reinserting the brew group'). You can use the grease tube multiple times. Cleaning the automatic milk frother Quick cleaning of the milk frothing system Note: Perform the quick cleaning procedure after brewing a milk-based beverage. 1 2 3 4 Place a cup under the automatic milk frother.
English 6 Rinse the jug with fresh water and fill it with half a liter of fresh water for the rinsing cycle. Empty the container and place it back under the automatic milk frother. 7 Insert the suction tube into the jug. 8 Press the MILK FROTH button. 9 You can press OK to stop or let the machine dispense until it stops automatically. 10 Disassemble the milk frother (see 'Disassembling the automatic milk frother ') and rinse all parts in lukewarm water or in the dishwasher.
English 21 the display, the machine will eventually stop working properly. In this case, repairs are not covered by the warranty. Only use Saeco descaling solution to descale the machine. Saeco descaling solution is designed to ensure optimal performance of the machine. The use of other products may damage the machine and leave residues in the water. You can buy Saeco descaling solution in the online shop at www.saeco.com/care.
English 2 1 XAM CLAC C NAEL CALC CLEAN 10 Fill the water tank with fresh water up to the CALC CLEAN level indication. Place the water tank back into the machine and press OK. 11 Remove and rinse the milk carafe. Fill the milk carafe with water up to the MIN level indication. Insert the milk carafe into the machine and open the milk froth dispensing spout. 12 Remove and empty the container and place it back under the coffee dispensing spout. Press OK to confirm.
English 23 Warning icons and error codes Meaning of the warning icons ADD WATER ADD COFFEE 10 SUPPORT REQUIRED Fill the water tank with fresh water to the MAX level indication. The coffee grounds container is full. Make sure the machine is switched on. Then remove and empty the coffee grounds container. The bean hopper is empty. Put new coffee beans in the bean hopper. The brew group is blocked by coffee powder. Clean the brew group.
English Error code Problem Cause Possible solution 05 There is a water circuit problem. There is air in the water circuit. Remove and place back the water tank a couple of times. Make sure you insert it into the machine properly. Check if the water tank compartment is clean. If you use an AquaClean filter: remove the AquaClean filter from the water tank and shake it to remove all air from the filter. Then place the AquaClean filter back into the water tank. 14 The machine is overheated.
English 25 Problem Cause Solution The 'coffee grounds container full' icon remains displayed. You emptied the coffee grounds container while the machine was switched off. Always empty the coffee grounds container while the machine is switched on. If you empty the coffee grounds container when the machine is switched off, the coffee cycle counter is not reset. In that case, the 'empty coffee grounds container' message stays on the display even though the container is not full.
English Problem Cause Solution The coffee is not hot enough. The cups you use are cold. Preheat the cups by rinsing them with hot water. The temperature is set too low. Set the temperature to 'high' in the Check the menu settings. menu. You added milk. The machine grinds the coffee beans, but coffee does not come out. The coffee comes out slowly. Whether the milk you add is warm or cold, it always decreases the temperature of the coffee to some extent. The coffee exit duct is blocked.
English 27 Problem Cause Solution I cannot activate the AquaClean filter and the machine asks for descaling. You have already replaced the AquaClean filter 8 times. After you have replaced the AquaClean filter 8 times, you need to descale the machine. Descale your machine first and install the AquaClean filter. Always activate the AquaClean filter in the menu. Also do this when you replace the filter.
English Problem Cause Solution There is water under the machine. The drip tray is too full and has overflowed. Empty the drip tray when the 'drip tray full' indicator pops up through the drip tray. Always empty the drip tray before you start descaling the machine. The machine is not placed on a Place the machine on a horizontal horizontal surface. surface so that the 'drip tray full' indicator works properly.
START DESCALING? 23 MIN
4219.460.3607.1 (9/2016) >75% recycled paper >75% papier recyclé www.saeco.